Jump to content

Everything 800mhz (1xA, LTE, coverage, timeline, etc)


Recommended Posts

I figured 800 would be a top priority to help cut roaming cost.  Is the setup more extensive?

 

Not sure what you're getting at? 800 is already installed, they're just waiting to activate. Probably waiting on crews to be available to do it, or perhaps carrier cards for the base stations. 

Link to comment
Share on other sites

Not sure what you're getting at? 800 is already installed, they're just waiting to activate. Probably waiting on crews to be available to do it, or perhaps carrier cards for the base stations. 

 

Sorry I just realized I didn't type the first sentence... My mind got ahead of my fingers.  What I mean to say was that the 800mhz rollout seemed someone what slow.  And just that, why wait to activate it when it can help with their bottom line?

Link to comment
Share on other sites

Not sure what you're getting at? 800 is already installed, they're just waiting to activate. Probably waiting on crews to be available to do it, or perhaps carrier cards for the base stations. 

 

Except in the IBEZ. There's no 800 equipment at all at most of those.

Link to comment
Share on other sites

Except in the IBEZ. There's no 800 equipment at all at most of those.

 

True, and won't be fore a while.

 

 

Sorry I just realized I didn't type the first sentence... My mind got ahead of my fingers.  What I mean to say was that the 800mhz rollout seemed someone what slow.  And just that, why wait to activate it when it can help with their bottom line?

 

Hence discussing we've been having.... no one is sure why it's not happening outside of the Samsung markets.

Link to comment
Share on other sites

True, and won't be fore a while.

 

 

 

Hence discussing we've been having.... no one is sure why it's not happening outside of the Samsung markets.

Markets that are Samsung make me jealous. :P  I think Samsung just has the most equipment/crews ready for the task.  800 Mhz will control voice and emergency calls so it has to be thoroughly tested prior to being activated. 

Link to comment
Share on other sites

Talk about coverage...I was down right by the ocean today driving in Kennebunkport, Maine and my phone picked up an 800 signal....from Mass.!  It seems the tower is out on a peninsula of sorts in rockport and it stuck out just enough to go clearly over the ocean almost 100 miles.

 

I suppose going over open water signal penetration is very good but I didnt think it was that good.  Very impressive.

 

What do you guys think?

Screenshot_2013-08-01-11-20-47.png

  • Like 6
Link to comment
Share on other sites

Except in the IBEZ. There's no 800 equipment at all at most of those.

This is a single data point only but I have a pic of 800 mHz RRUs on a site in Poway. They are not hooked up or weren't about ten months ago when I took the picture.

Link to comment
Share on other sites

Talk about coverage...I was down right by the ocean today driving in Kennebunkport, Maine and my phone picked up an 800 signal....from Mass.!  It seems the tower is out on a peninsula of sorts in rockport and it stuck out just enough to go clearly over the ocean almost 100 miles.

 

Were you at the George H. W. Bush compound?  I would have to say, though, that using even CDMA1X 800 from 100 miles away probably "wouldn't be prudent at this juncture."

 

AJ

Link to comment
Share on other sites

Talk about coverage...I was down right by the ocean today driving in Kennebunkport, Maine and my phone picked up an 800 signal....from Mass.! It seems the tower is out on a peninsula of sorts in rockport and it stuck out just enough to go clearly over the ocean almost 100 miles.

 

I suppose going over open water signal penetration is very good but I didnt think it was that good. Very impressive.

 

What do you guys think?

Impressive! I saw something similar last summer before we had 800 around here.. I was hitting a 1X site in Maine from near the end of Cape Cod. It was not very usable for data though, it was much weaker than what you saw.

 

-Mike

Link to comment
Share on other sites

Were you at the George H. W. Bush compound?  I would have to say, though, that using even CDMA1X 800 from 100 miles away probably "wouldn't be prudent at this juncture."

 

AJ

I actually was right by it.  Quite an impressive place.  I dont usually go down there this time of year as the "flat-landers" have invaded though. ;)

 

Is there any sort of numbers that show how far a cell signal can travel over open water, unobstructed?

 

Also, for those around that area in Mass.. that cell site does not appear to be 800 accepted yet but it is broadcasting it so it must be close.

Link to comment
Share on other sites

Impressive! I saw something similar last summer before we had 800 around here.. I was hitting a 1X site in Maine from near the end of Cape Cod. It was not very usable for data though, it was much weaker than what you saw.

 

-Mike

 

Both reports bring back memories of Nextels on the Michigan side of the lake hooking up with Wisconsin towers.

  • Like 1
Link to comment
Share on other sites

This is a single data point only but I have a pic of 800 mHz RRUs on a site in Poway. They are not hooked up or weren't about ten months ago when I took the picture.

 

Huh. I wonder if I should do some driving up there.

Link to comment
Share on other sites

This would be nice... It would be nice to know that when they are activating a tower to know that we are getting SMR, PCS, BRS as well as LTE, CDMA, 1X *and* cream and sugar!

 

What's BRS?

Edited by DrDeke
Link to comment
Share on other sites

To those of you who have 800Mhz signal, how well does voice call transition between 800/1900.  Does it drop the call?

I dropped one the other day.  But I went from Sprint 1x 800 to a 1900 roaming signal so I'm sure that opens up a whole new can of worms

Link to comment
Share on other sites

I actually was right by it. Quite an impressive place. I dont usually go down there this time of year as the "flat-landers" have invaded though. ;)

 

Is there any sort of numbers that show how far a cell signal can travel over open water, unobstructed?

 

Also, for those around that area in Mass.. that cell site does not appear to be 800 accepted yet but it is broadcasting it so it must be close.

Every site is different of course. But I have seen LTE at about 14 miles over water from a 180ft 33 degree beam width antenna. I can only imagine 1x 800 from this same style site. I am sure there is more downtilt involved though as to cut down on interference.

Link to comment
Share on other sites

I haven't experienced any drop calls

You are located within Shentel's area which is almost totally equipped with 800 mhz.   If you travel outside the Shentel area, you might find a completely different result.   Areas that are a mixture of 1900 only sites and sites with both 1900 and 800 could possibly give you some weird issues.

Link to comment
Share on other sites

I dropped one the other day.  But I went from Sprint 1x 800 to a 1900 roaming signal so I'm sure that opens up a whole new can of worms

 

With rare exception, a native call is not going to hand off to roaming (nor vice versa).  The frequency band change is irrelevant.

 

AJ

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Similar Content

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...