Jump to content

Network Vision/LTE - New York City Market


Ace41690

Recommended Posts

Not really. It just means that Brooklyn and the Bronx have towers in enough areas that they consider it complete. Lets that number is 75%. And let's say queens and manhattan are at the 30% mark. It will still be deployed more and more. But u gotta was till 75 until its (official)

Take a look at sensorly. The Bronx seems to have pretty good coverge. I have to believe that next to Manhattan, the Bronx is one of the most challenging places to build out. It is a dense urban environment with a lot of hills. You may be dropping LTE intermittantly for awhile.

Link to comment
Share on other sites

Yonkers may be on the list, but I can tell you that there is still a lot of work to be done here. The tower next to my home has yet to be marked 3g complete, and from what I can see, has had new panels installed since last summer.... 4g coverage in Yonkers in my opinion is about 40% complete.

 

Sent from my HTCONE using Tapatalk 2

If im not mistaken, Sprint does announce a city once it hits around the 40% mark. So that might explain.

Link to comment
Share on other sites

If im not mistaken, Sprint does announce a city once it hits around the 40% mark. So that might explain.

 

So far as we know, they announce at the 40% POPs mark. Not even 40% complete site wise, just POPs. I'm pretty sure they waited a little longer for NYC due to all the holes, and other large cities such as LA and DC (still not announced), but elsewhere that 40% POPs seems to be holding pretty well. (Portland, Nashville, Jacksonville FL to name a few).

  • Like 1
Link to comment
Share on other sites

Thus far, no change in service.

 

*plays violin tune*

 

The way I see it, upgrades are surely coming, when sprint says "in the coming months" they actually mean a year and change, and never hype up press releases.

  • Like 2
Link to comment
Share on other sites

I really don't understand how or why Sprint went from deploying LTE at a super fast paste to this sluggy taking 10-15years paste of deployment . This slowness is gonna work against them in the long run cause mean while they're taking their time they're also losing customers who became impatient . They need to speed it up *claps hands rapidly*

 

 

Sent from my iPhone 5 using Tapatalk

Seriously?

 

Dude, seriously?

  • Like 3
Link to comment
Share on other sites

?

 

 

Sent from my iPhone 5 using Tapatalk

 

They're still progressing at the same speed they have been all year. Sure, couple weeks here and there are a bit slower, a couple a bit faster. But the rollout hasn't stalled, or stopped. It's still chugging along. 

Link to comment
Share on other sites

I can attest to the fact as someone that lives and travels through brooklyn that the LTE is very spotty, non contiguous and mostly absurdly slow for LTE. I have never had LTE in my home neighborhood for more than 12 hrs. When I travel LTE is constantly dropping and failing to reconnect.

Link to comment
Share on other sites

I can attest to the fact as someone that lives and travels through brooklyn that the LTE is very spotty, non contiguous and mostly absurdly slow for LTE. I have never had LTE in my home neighborhood for more than 12 hrs. When I travel LTE is constantly dropping and failing to reconnect.

Thats what I experience . My phone rarely connects to LTE willingly its always me forcing it onto the network through Airplane Mode . Unfortunately thats the only way I can experience LTE .

 

 

Sent from my iPhone 5 using Tapatalk

Link to comment
Share on other sites

One thing that I have noticed about the way handing off works with regards to switching from 3G to 4G and vice versa, if your phone, is constantly accessing that data connection (be it 3G or 4G) it will not hand off, the phone will wait, until its in an idle state, THEN switch. So for example, if your in a 3G only area, and you happen to travel within a 4G coverage area while your phone is accessing data, it will NOT hand off to 4G until the radio is in an idle state! So bottom line, switching to airplane mode will just stop your radio from accessing the network and wake up in the preferred state (hopefully LTE). Also, try to keep those background apps at bay, it will greatly reduce the time it takes to switch radio modes.

  • Like 3
Link to comment
Share on other sites

One thing that I have noticed about the way handing off works with regards to switching from 3G to 4G and vice versa, if your phone, is constantly accessing that data connection (be it 3G or 4G) it will not hand off, the phone will wait, until its in an idle state, THEN switch. So for example, if your in a 3G only area, and you happen to travel within a 4G coverage area while your phone is accessing data, it will NOT hand off to 4G until the radio is in an idle state! So bottom line, switching to airplane mode will just stop your radio from accessing the network and wake up in the preferred state (hopefully LTE). Also, try to keep those background apps at bay, it will greatly reduce the time it takes to switch radio modes.

That's a good point I always thought it was my EVO LTE with it's connection problems that was causing this so I guess this happens to all devices.

 

Sent from my Nexus 7

 

 

  • Like 1
Link to comment
Share on other sites

One thing that I have noticed about the way handing off works with regards to switching from 3G to 4G and vice versa, if your phone, is constantly accessing that data connection (be it 3G or 4G) it will not hand off, the phone will wait, until its in an idle state, THEN switch. So for example, if your in a 3G only area, and you happen to travel within a 4G coverage area while your phone is accessing data, it will NOT hand off to 4G until the radio is in an idle state! So bottom line, switching to airplane mode will just stop your radio from accessing the network and wake up in the preferred state (hopefully LTE). Also, try to keep those background apps at bay, it will greatly reduce the time it takes to switch radio modes.

Spot on. 100 percent agree. Experiencing the same.

Link to comment
Share on other sites

Considering over the last two weeks we had only about 10 new NV sites, I would say they have been slow recently. And NYC isn't even half way done.

 

I don't think work has slowed down as much as it is going as fast as possible. I seriously doubt the techs are sitting on their thumbs.

Link to comment
Share on other sites

Kinda surprised u didn't know about this

I didn't. Usually I'm on the train using data and it would switch to 3G/4G during tower handoffs.

 

I tested this from a static position yesterday with 4G coverage. iPhone was on 3G and wouldn't go to 4G. Cycled airplane mode and it connected to 4G right away.

 

You could say that I just never noticed it.

Link to comment
Share on other sites

I didn't. Usually I'm on the train using data and it would switch to 3G/4G during tower handoffs.

 

I tested this from a static position yesterday with 4G coverage. iPhone was on 3G and wouldn't go to 4G. Cycled airplane mode and it connected to 4G right away.

 

You could say that I just never noticed it.

I hope 800 signal will be auto in real time. Not airplane mode cycle

Link to comment
Share on other sites

im on 82 st and northern blvd jackson heights queens, i added a screen shot something is not right the bsl gives me an adress in the bronx

 

Sent from my Nexus 10 using Tapatalk HD

uploadfromtaptalk1375374587622.jpg

  • Like 4
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Similar Content

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...