Jump to content

Official Magic Box discussion thread


lilotimz

Recommended Posts

4 hours ago, Nickmb said:

Hi  Can anybody tell me if these seem like reasonable numbers with the new magic Box. When it 1st boots up in only finds one bar

 

The problem is I do not know if that 1 bar is from band 41 or banned 25 as the magic Box can use either  donor ban.

 Anyways before the magic Box I was getting from 7 to 12 megabits download and now I'm getting 10 does that seem reasonable The band 41 tower is exactly one mile from my house. But using LTE discovery app when the magic Box is not active I cannot see band 41 whatsoever only ban 25. Any help appreciated.

Resized_20171217_131523_2763.jpg

Before connecting the MB, verify the PCI and band to see if it matches the ID the MB is connected to. If it is B25, you probably won't see much speed improvements since it is -113 RSRP from your screenshot. 

Link to comment
Share on other sites

15 hours ago, bucdenny said:

Before connecting the MB, verify the PCI and band to see if it matches the ID the MB is connected to. If it is B25, you probably won't see much speed improvements since it is -113 RSRP from your screenshot. 

Thanks for reply

Link to comment
Share on other sites

I went weeks and weeks without a problem of my phone connecting to the mb and now for the past week or so, it has refused to connect.  :(

 

Wifes phone (same model as mine... 256gb iPhone 10), on the other hand, connects reliably.  Grrrrrr

Link to comment
Share on other sites

Hey you guys I have a question. I am try to attach an external antenna to the magic Box device. After taking the cover off I notice there were 2 major and antennas one  back facing out the window and 1 facing Inside. My question is the antenna facing out towards the cell tower to establish a relay connection has 5 wires going in to the central tx.rx  unit.  One wire is labeled antenna. The other 4 wires are labeled ABC and D.  Are the 4 wires label ABC and D related to 4 by 4 mimo. If so would even make sense connecting all these to a single external antenna?  Or what I in reality have to attach four external antennas to each of the 4 wires.  Any help on this matter is greatly appreciate.

Link to comment
Share on other sites

On 12/21/2017 at 2:05 PM, Nickmb said:

Hey you guys I have a question. I am try to attach an external antenna to the magic Box device. After taking the cover off I notice there were 2 major and antennas one  back facing out the window and 1 facing Inside. My question is the antenna facing out towards the cell tower to establish a relay connection has 5 wires going in to the central tx.rx  unit.  One wire is labeled antenna. The other 4 wires are labeled ABC and D.  Are the 4 wires label ABC and D related to 4 by 4 mimo. If so would even make sense connecting all these to a single external antenna?  Or what I in reality have to attach four external antennas to each of the 4 wires.  Any help on this matter is greatly appreciate.

pics please

  • Like 1
Link to comment
Share on other sites

On 12/18/2017 at 10:12 AM, shaferz said:

Confused.  Here is what mine shows.  :dunno:

 

SW Ver: 15.15.10.141

                60.6.40.2

 

Update - 

 

Sometime over the past day or two, my magic box updated to:

 

SW Ver: 15.15.10.141

                60.6.58.0

 

... which appears to be back to the version where the home screen displays LTE, Sprint, and GPS Icons in the top right hand corner.  Interestingly, over the past day or two, my phone seems to prefer the Magic Box again.  Woohoo!!

  • Like 2
Link to comment
Share on other sites

On 10/5/2017 at 8:04 PM, belusnecropolis said:

Yes, that is the LTE radio. The FCC docs don't have any components on the boards so I wondered what it looked like in there all put together, so I took it apart.

 Hey I appreciate you go to the effort to take their picture I have been trying to track that device down to figure out what 4 wires are about. Do you know what the device is called so I can search it on the Web to find out more information about it.  If the wires are for antennas  than I can connect external antennas to the device through those wires.  Thanks for any info you might be able to provide.

Link to comment
Share on other sites

3 hours ago, Nickmb said:

 Hey I appreciate you go to the effort to take their picture I have been trying to track that device down to figure out what 4 wires are about. Do you know what the device is called so I can search it on the Web to find out more information about it.  If the wires are for antennas  than I can connect external antennas to the device through those wires.  Thanks for any info you might be able to provide.

I'll put something together for you later or tomorrow to try to help explain. 

Link to comment
Share on other sites

1 hour ago, belusnecropolis said:

I'll put something together for you later or tomorrow to try to help explain. 

I really appreciate it.  Like I mentioned in my earlier post I did something similar to this to receive Wi-Fi over 5 miles. I certainly do not claim to be an expert, But I am thinking LTE cellular is going to be a little more difficult.

Link to comment
Share on other sites

43 minutes ago, Nickmb said:

I really appreciate it.  Like I mentioned in my earlier post I did something similar to this to receive Wi-Fi over 5 miles. I certainly do not claim to be an expert, But I am thinking LTE cellular is going to be a little more difficult.

Yeah I generally have no idea what I am doing when I get into this stuff. I am good at research so that makes it a bit easier. There are a few things you have to pay attention to with licensed spectrum and antennae but it is similar in executing a result.

Link to comment
Share on other sites

5 minutes ago, belusnecropolis said:

Yeah I generally have no idea what I am doing when I get into this stuff. I am good at research so that makes it a bit easier. There are a few things you have to pay attention to with licensed spectrum and antennae but it is similar in executing a result.

Thanks wife and i going to c star wars be back here later tonite have a good one

Link to comment
Share on other sites

On 12/21/2017 at 2:05 PM, Nickmb said:

Hey you guys I have a question. I am try to attach an external antenna to the magic Box device. After taking the cover off I notice there were 2 major and antennas one  back facing out the window and 1 facing Inside. My question is the antenna facing out towards the cell tower to establish a relay connection has 5 wires going in to the central tx.rx  unit.  One wire is labeled antenna. The other 4 wires are labeled ABC and D.  Are the 4 wires label ABC and D related to 4 by 4 mimo. If so would even make sense connecting all these to a single external antenna?  Or what I in reality have to attach four external antennas to each of the 4 wires.  Any help on this matter is greatly appreciate.

A note.  A disclaimer if you will...

We will allow this post to stay here.  But know that taking apart leased/lent equipment is likely a violation of your agreement, and not advisable.  We do not endorse/encourage it.  You will likely be liable for damaged and even possibly having your account canceled should Sprint discover it.  

We have moved this to the Magic Box thread.

Robert

  • Like 1
Link to comment
Share on other sites

Got another call asking if I would return the box. It got an update over the past day or two to .141. stuck on "Configuring LTE Service" though :(

Apparently this area doesn't have a dedicated B41 uplink carrier for these, and there's no ETA on when we'll get one, so it'll probably get boxed up tomorrow :(

Link to comment
Share on other sites

  • 2 weeks later...
On 12/17/2017 at 1:29 PM, Nickmb said:

Hi  Can anybody tell me if these seem like reasonable numbers with the new magic Box. When it 1st boots up in only finds one bar

 

The problem is I do not know if that 1 bar is from band 41 or banned 25 as the magic Box can use either  donor ban.

 Anyways before the magic Box I was getting from 7 to 12 megabits download and now I'm getting 10 does that seem reasonable The band 41 tower is exactly one mile from my house. But using LTE discovery app when the magic Box is not active I cannot see band 41 whatsoever only ban 25. Any help appreciated.

 

Your MB is connected to Band 41. 10 Mbps download sounds about right with that CINR and RSRP it is displaying. You're probably sitting between cells in a null area for B41.

The B25 carrier is probably a lot cleaner and is not congested (which is why you get 7-12 Mbps).

And before you ask, NO...there is no way to force the MB to choose B25 as the donor band over B41. Only way to do that is to get creative.

Link to comment
Share on other sites

Got my magic box today. I have tried many locations but it will not complete setup. It usually detects the network but then says something to the effect of failed to complete setup at this location. I have placed it outside even where my phone a S7 reports band 41 signal at -99 RSRP and still no luck. Would it help if i take the magic box closer to the tower and try again so it can at least update firmware? Oh and this market does have the high/low spectrum split needed for b41 magic box operations.

 

Sent from my SM-G930P using Tapatalk

 

 

 

 

Link to comment
Share on other sites

2 hours ago, superbluepsd said:

Got my magic box today. I have tried many locations but it will not complete setup. It usually detects the network but then says something to the effect of failed to complete setup at this location. I have placed it outside even where my phone a S7 reports band 41 signal at -99 RSRP and still no luck. Would it help if i take the magic box closer to the tower and try again so it can at least update firmware? Oh and this market does have the high/low spectrum split needed for b41 magic box operations.

 

Sent from my SM-G930P using Tapatalk

 

Contact the MB support line. Could be the Donor tower needs a software toggle to support MBs.

Link to comment
Share on other sites

 
Contact the MB support line. Could be the Donor tower needs a software toggle to support MBs.
Thanks. I took it close to a b41 macro using the battery and it got to the excellent signal screen so i pushed continue setup and it wants to be plugged in to continue so will have to try it at home again plugged in.

Sent from my SM-G930P using Tapatalk

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...