Jump to content

Everything 800mhz (1xA, LTE, coverage, timeline, etc)


Recommended Posts

This may be a dumb question, but was 800 LTE installed at the time when CDMA 800 was installed? Or is there a completely separate rollout for 800LTE?

All the equipment was installed at the same time, except the carrier cards. LTE 800 will require a separate roll out to each site to install a carrier card and integrate. The carrier cards were not available from most OEM's until recently.

 

Robert via Samsung Note 8.0 using Tapatalk Pro

 

 

  • Like 3
Link to comment
Share on other sites

This may be a dumb question, but was 800 LTE installed at the time when CDMA 800 was installed? Or is there a completely separate rollout for 800LTE?

CDMA 800 is installed with the initial equipment install. It just varies when it's turned on.

  • Like 1
Link to comment
Share on other sites

CDMA 800 is installed with the initial equipment install. It just varies when it's turned on.

Beat ya! ;)

 

Robert via Samsung Note 8.0 using Tapatalk Pro

 

 

  • Like 1
Link to comment
Share on other sites

All the equipment was installed at the same time, except the carrier cards. LTE 800 will require a separate roll out to each site to install a carrier card and integrate. The carrier cards were not available from most OEM's until recently.

 

Robert via Samsung Note 8.0 using Tapatalk Pro

Thanks. I've been wondering about that.

 

Sent from my Nexus 5 using Tapatalk

 

 

Link to comment
Share on other sites

Wish there was a way I could force 800 on, I see it pop up at my house occasionally and I'm on a airave and my airave signal is shady at best.

 

Sent from my SPH-L710 using Tapatalk

You're a sponsor. Load up digiblur's custom PRL on your phone.

  • Like 2
Link to comment
Share on other sites

Are there any drawbacks in doing so?

 

You may connect to a CDMA 800 site that is on the test SID, which could mean it's not ready for full action for one reason or another. If you are on a telephone call initiated on CDMA 800, it will be dropped if you are no longer in range of any CDMA 800 signals. I believe the proper term for switching between 800MHz<->1900MHz is a "hard handoff" -- your phone will switch bands, but you will be disconnected when it happens.

 

-Mike

Link to comment
Share on other sites

https://www.dropbox.com/s/f8jkxipbgatvswr/Screenshot_2014-01-19-16-21-49.png

 

What is 4GV_NB under the SO? It was what showed up when I made a call to test it out.

Link to comment
Share on other sites

https://www.dropbox.com/s/f8jkxipbgatvswr/Screenshot_2014-01-19-16-21-49.png

 

What is 4GV_NB under the SO? It was what showed up when I made a call to test it out.

 

From another recent post where someone else asked.. http://s4gru.com/index.php?/topic/5115-is-hd-voice-now-on-mine-appears-to-be-working/?p=256928:

 

That is EVRC-NW in narrowband mode.

-Mike

Link to comment
Share on other sites

 

From another recent post where someone else asked.. http://s4gru.com/index.php?/topic/5115-is-hd-voice-now-on-mine-appears-to-be-working/?p=256928:

 

-Mike

Thank you, what will show up when 1x advanced is out, or HD voice?

Link to comment
Share on other sites

I had some questions on how know if your on sprint 1x800 and not roaming or some other phantom signal? I have roaming turned off most of the time and I am on prl 513 from here.

 

I was in Tulsa, OK and now mobile, AL. Both places no one else has connected to 1x800 and both I didn't see an address in SCP. Here are some screenshots from al tower. I was heading east on I-10 I didn't see 1x800 until I was under the tunnel it lasted until I got off the bridge.

 

https://www.dropbox.com/s/jnzh9ixvdfin4wx/Screenshot_2014-01-22-08-41-23.png

https://www.dropbox.com/s/6polqgqo25lsmv6/Screenshot_2014-01-22-08-41-04.png

https://www.dropbox.com/s/48bg4elre8m1bzy/Screenshot_2014-01-22-08-45-25.png

https://www.dropbox.com/s/2uawa7q3a461leo/Screenshot_2014-01-22-08-40-30.png

  • Like 2
Link to comment
Share on other sites

I had some questions on how know if your on sprint 1x800 and not roaming or some other phantom signal? I have roaming turned off most of the time and I am on prl 513 from here.

 

I was in Tulsa, OK and now mobile, AL. Both places no one else has connected to 1x800 and both I didn't see an address in SCP. Here are some screenshots from al tower. I was heading east on I-10 I didn't see 1x800 until I was under the tunnel it lasted until I got off the bridge.

 

https://www.dropbox.com/s/jnzh9ixvdfin4wx/Screenshot_2014-01-22-08-41-23.png

https://www.dropbox.com/s/6polqgqo25lsmv6/Screenshot_2014-01-22-08-41-04.png

https://www.dropbox.com/s/48bg4elre8m1bzy/Screenshot_2014-01-22-08-45-25.png

https://www.dropbox.com/s/2uawa7q3a461leo/Screenshot_2014-01-22-08-40-30.png

You did surely have Sprint 1X 800 and a weak 1900 LTE signal. You did not get a street address for the site because your 1900 LTE was so weak that your phone could not communicate with Google over the LTE to get an address.  You were not very close to the site(s) involved.   The 800 probably was able to go "under the tunnel" and the signal was stronger than any 1900 signal.  Anytime the 1900 signal drops, the phone will search for 800.

Link to comment
Share on other sites

You did surely have Sprint 1X 800 and a weak 1900 LTE signal. You did not get a street address for the site because your 1900 LTE was so weak that your phone could not communicate with Google over the LTE to get an address.  You were not very close to the site(s) involved.   The 800 probably was able to go "under the tunnel" and the signal was stronger than any 1900 signal.  Anytime the 1900 signal drops, the phone will search for 800.

The 1x signal would be carrying the latitude and longitude signalcheck pro would show "click for map" if no data.

 

I am on prl 513 found in the premier forums which has 800 at a higher priority.

Link to comment
Share on other sites

I had some questions on how know if your on sprint 1x800 and not roaming or some other phantom signal? I have roaming turned off most of the time and I am on prl 513 from here.

 

I was in Tulsa, OK and now mobile, AL. Both places no one else has connected to 1x800 and both I didn't see an address in SCP. Here are some screenshots from al tower. I was heading east on I-10 I didn't see 1x800 until I was under the tunnel it lasted until I got off the bridge.

 

https://www.dropbox.com/s/jnzh9ixvdfin4wx/Screenshot_2014-01-22-08-41-23.png

https://www.dropbox.com/s/6polqgqo25lsmv6/Screenshot_2014-01-22-08-41-04.png

https://www.dropbox.com/s/48bg4elre8m1bzy/Screenshot_2014-01-22-08-45-25.png

https://www.dropbox.com/s/2uawa7q3a461leo/Screenshot_2014-01-22-08-40-30.png

 

Interesting...the first 487 we've seen!  Probably from them having to deal with SoutherLinc.

  • Like 2
Link to comment
Share on other sites

Interesting...the first 487 we've seen!  Probably from them having to deal with SoutherLinc.

 

Yes, Mobile is a SouthernLINC market.

 

AJ

Link to comment
Share on other sites

The 1x signal would be carrying the latitude and longitude signalcheck pro would show "click for map" if no data.

Correct. You were connected to CDMA 800 (the SID and channel 487 confirm that), but that site was broadcasting invalid location coordinates.. that is why the BSL line is missing. You can see on the engineering screen it says latitude 0 (the longitude is unreliable; it is almost always wrong on Samsung devices).

 

-Mike

  • Like 2
Link to comment
Share on other sites

Guest DigiClaws

Would it not be beneficial for Sprint to buy SouthernLinc for their spectrum as well as their coverage of the southeast? Does Sprint have an exclusive roaming agreement with SouthernLInc in that area or do they also have roaming agreements with Verizon?

Link to comment
Share on other sites

Would it not be beneficial for Sprint to buy SouthernLinc for their spectrum as well as their coverage of the southeast? Does Sprint have an exclusive roaming agreement with SouthernLInc in that area or do they also have roaming agreements with Verizon?

It would be great for Sprint to buy it. But they are not for sale. SouthernLinc is owned by Southern Companies. Their wireless company is for its personal use. They like it like that.

 

Robert via Nexus 5 using Tapatalk

 

 

  • Like 2
Link to comment
Share on other sites

Would it not be beneficial for Sprint to buy SouthernLinc for their spectrum as well as their coverage of the southeast? Does Sprint have an exclusive roaming agreement with SouthernLInc in that area or do they also have roaming agreements with Verizon?

 

It's a small batch of spectrum... Not sure if it is worth buying the whole company.  May be wrong though.

Link to comment
Share on other sites

It would be great for Sprint to buy it. But they are not for sale. SouthernLinc is owned by Southern Companies. Their wireless company is for its personal use. They like it like that.

 

Ah, the almighty Southern Company...

 

;)

 

AJ

  • Like 4
Link to comment
Share on other sites

Does Sprint have an exclusive roaming agreement with SouthernLInc in that area or do they also have roaming agreements with Verizon?

 

SouthernLINC had a roaming agreement with Sprint, but it is now defunct.  SouthernLINC is an iDEN operator.

 

AJ

  • Like 3
Link to comment
Share on other sites

Glad to hear of some 800MHZ in the southeast, i wasn't sure we'd get any soon because of southern-link! That 800 love needs to move on to Georgia, it will be really nice in the rural areas...

Link to comment
Share on other sites

It would be great for Sprint to buy it. But they are not for sale. SouthernLinc is owned by Southern Companies. Their wireless company is for its personal use. They like it like that.

 

Robert via Nexus 5 using Tapatalk

Just what I need, my own personal network so AJ can't complain about the bandwidth I am or am not using...  :rasp:

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...