Jump to content

Network Vision/LTE - Puerto Rico/Virgin Islands Market


Gab2012

Recommended Posts

PR03XC151 this one appears to be completed and when make a speed test with 3g the speed is not good Robert
OK. So noted. What would you like me to do?

 

Robert via Nexus 7 on Tapatalk

 

 

  • Like 1
Link to comment
Share on other sites

im just saying like what happen there does the 3g speed supost to be faster right
Someone else had the same issue about 15 posts back in this thread and we discussed it. Same answer applies in your instance.

 

Robert via Nexus 7 on Tapatalk

 

 

Link to comment
Share on other sites

I don't yet have LTE in St Thomas and I have an iPhone 5, is there anything that I should do in preparation for LTE? Will I need to take my phone to the sprint store to get PR LTE enable?

 

Thanks

 

no special preparations needed. Just sit tight and use it as you normally would until LTE is deployed.

  • Like 1
Link to comment
Share on other sites

are there any special steps required to get NetMonitor to display the towers? I've run it, and doesn't display any towers around me.

 

thanks guys

When that happened to me, I just turn my gps on and try to get a lock.. after that just let them collect the towers info..

Sometimes I need to zoom in/out so it shows me the towers

 

Sent from my SPH-L900 using Tapatalk 2

 

Please keep in mind that tower locations can be highly inaccurate when using netmonitor/opensignal.

Link to comment
Share on other sites

I just got LTE in my mothers house in Puerto Nuevo. Just one bar though.

 

LTE is not measured with bars. You could be connecting to a LTE tower 40 feet from you and be connected to voice to a tower 1 mile away from you and it will only show the voice signal.

  • Like 1
Link to comment
Share on other sites

LTE is not measured with bars. You could be connecting to a LTE tower 40 feet from you and be connected to voice to a tower 1 mile away from you and it will only show the voice signal.

 

We have found that the iPhone does display LTE signal strength in bars, since it can only use one antenna at a time.

  • Like 2
Link to comment
Share on other sites

Well Claro Puerto Rico yesterday launch its 4g LTE service ,in the initial phase ; san juan ponce and mayaguez, 19 towns total. In the first quarter of 2013 they expect to covers the entire island. I hope Sprint surprise then in the initial lunch.........

  • Like 2
Link to comment
Share on other sites

I got Sprint LTE in La Catolica,Ponce PR

I was the one who mapped the campus in sensorly! :D I only manage to get LTE from Gonzalez Pato to the Sports complex, no LTE in the McManus area or the library.
Link to comment
Share on other sites

When I go into Data Management ##3282# under advanced, it says LTE disabled on my phone even though its on LTE/CDMA. Should it be like that?

I noticed that I have the same issue. Is there any way to change that parameter to LTE Enable? My PRL version is 25009
Link to comment
Share on other sites

I noticed that I have the same issue. Is there any way to change that parameter to LTE Enable? My PRL version is 25009

 

I'm not sure what the setting is for, but I was able to connect to lte with it set to disabled.

 

Prior to the Jelly Bean update, it was set to enabled.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Historically, T-Mobile has been the only carrier contracting with Crown Castle Solutions, at least in Brooklyn. I did a quick count of the ~35 nodes currently marked as "installed" and everything mapped appears to be T-Mobile. However, they have a macro sector pointed directly at this site and seem to continue relying on the older-style DAS nodes. Additionally, there's another Crown Castle Solutions node approved for construction just around the corner, well within range of their macro. I wouldn’t be surprised to see Verizon using a new vendor for their mmWave build, especially since the macro site directly behind this node lacks mmWave/CBRS deployment (limited to LTE plus C-Band). However, opting for a multi-carrier solution here seems unlikely unless another carrier has actually joined the build. This node is equidistant (about five blocks) between two AT&T macro sites, and there are no oDAS nodes deployed nearby. Although I'm not currently mapping AT&T, based on CellMapper, it appears to be right on cell edge for both sites. Regardless, it appears that whoever is deploying is planning for a significant build. There are eight Crown Castle Solutions nodes approved for construction in a 12-block by 2-block area.
    • Starlink (1900mhz) for T-Mobile, AST SpaceMobile (700mhz and 850mhz) for AT&T, GlobalStar (unknown frequency) for Apple, Iridium (unknown frequency) for Samsung, and AST SpaceMobile (850mhz) for Verizon only work on frequency bands the carrier has licensed nationwide.  These systems broadcast and listen on multiple frequencies at the same time in areas much wider than normal cellular market license areas.  They would struggle with only broadcasting certain frequencies only in certain markets so instead they require a nationwide license.  With the antennas that are included on the satellites, they have range of cellular band frequencies they support and can have different frequencies with different providers in each supported country.  The cellular bands in use are typically 5mhz x 5mhz bands (37.5mbps total for the entire cell) or smaller so they do not have a lot of data bandwidth for the satellite band covering a very large plot of land with potentially millions of customers in a single large cellular satellite cell.  I have heard that each of Starlink's cells sharing that bandwidth will cover 75 or more miles. Satellite cellular connectivity will be set to the lowest priority connection just before SOS service on supported mobile devices and is made available nationwide in supported countries.  The mobile device rules pushed by the provider decide when and where the device is allowed to connect to the satellite service and what services can be provided over that connection.  The satellite has a weak receiving antenna and is moving very quickly so any significant obstructions above your mobile device antenna could cause it not to work.  All the cellular satellite services are starting with texting only and some of them like Apple's solution only support a predefined set of text messages.  Eventually it is expected that a limited number of simultaneous voice calls (VoLTE) will run on these per satellite cell.  Any spare data will then be available as an extremely slow LTE data connection as it could potentially be shared by millions of people.  Satellite data from the way these are currently configured will likely never work well enough to use unless you are in a very remote location.
    • T-Mobile owns the PCS G-block across the contiguous U.S. so they can just use that spectrum to broadcast direct to cell. Ideally your phone would only connect to it in areas where there isn't any terrestrial service available.
    • So how does this whole direct to satellite thing fit in with the way it works now? Carriers spend billions for licenses for specific areas. So now T-Mobile can offer service direct to customers without having a Terrestrial license first?
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...