Jump to content

Breaking Band: Tri-band LTE / eCSFB issues thread


Recommended Posts

LTE is for data only. no device uses lte to send sms on the sprint network

Uh, no. Your post is incorrect. Posts above already correctly cite that e/CSFB devices can idle solely on LTE and send/receive SMS tunneled through LTE.

 

AJ

  • Like 1
Link to comment
Share on other sites

LTE is not used to send sms on Sprint

When my Nexus 5 is in LTE only mode, sms will not send or receive. But when not in LTE only mode and connected to LTE, sms will send and receive over LTE without dropping back to 1X. I wonder what is different about AT&T's eCSFB enabled LTE network that allows sms while in LTE only mode.

Link to comment
Share on other sites

LTE is not used to send sms on Sprint

 

No, you need to back up that assertion with evidence.  Your word is not sufficient.  Plenty of other posters, who are likely more knowledgeable on the matter than you are, have technical and empirical experience to the contrary.  e/CSFB is using LTE as the bearer for SMS.

 

AJ

  • Like 4
Link to comment
Share on other sites

No, you need to back up that assertion with evidence.  Your word is not sufficient.  Plenty of other posters, who are likely more knowledgeable on the matter than you are, have technical and empirical experience to the contrary.  e/CSFB is using LTE as the bearer for SMS.

 

AJ

they all have empirical evidence, my knowledge or word on this subject comes from my day to day lively hood.

Link to comment
Share on other sites

Grandma:  " Johnny, did you shoot my favorite pee-wee with your BB Gun?"

Johnny:      " No Grandma, my cousin Paul here shot your bird!!"

Paul:           " Grandma, I didn't shoot your bird, Johnny did!!

Grandma:    "Someone is not telling the truth"

  • Like 1
Link to comment
Share on other sites

That link proves nothing , currently sprint has implemented LTE for data only.. everyone knows LTE standard has sms and voice protocols built in Sprint, has yet to implement those feature

That is incorrect. If you use a tri-band device to send a text the phone does not drop to 1x, it stays on LTE the entire time. Same with receiving texts.
Link to comment
Share on other sites

my experience with lte mode only, appears to force the device to DATA ONLY, which blocks the sms tunneling/signalling available when lte/3g mode is enabled.

Link to comment
Share on other sites

I think it's funny this has been argued over such a long amount of time... SMS can, and DOES runs over LTE...It's been proven. No need to go on this merry-go-round....Disregard user as troll and move on...

 

  • Like 3
Link to comment
Share on other sites

And just as a refresher....SMS/MMS over LTE is possible by a thing called, "Message Transfer over IMS" (IP Multimedia Subsystem). The functionality of this is to provide legacy "Switched" services over an IP Network (ie. LTE). The IMS can be used for Voice, SMS, MMS, etc. by sending them over an IP Link from the UE (User Equipment/Handest) to a gateway. Then the gateway converts it back to a "Circuit Switched" service back at the MSC (or wherever the IMS Gateway is for Sprint). Right now Sprint is only using this for SMS/MMS, but it can and will be utilized for the transition from "Circuit Switched Voice" to VoLTE to connect back to the PSTN Network. This is why were still using eSCFB (FOR CALLS ONLY) think of the name... Circuit Switched FALL BACK (Falls back to the Circuit Switched network) for the call. eCSFB does not provide the SMS/MMS Link. It only switches you back to 3G For a Circuit Switched service that cannot be provided over IP.

 

Now for the IP Link, think of it like a SIP Link. It converts the SMS/MMS to a SIP type address and forwards it out to the gateway for processing. All done over IP. If you fall back to 3G/1x...then it goes back to the old Circuit Switched method...It was designed this way for seamless use while on LTE and for the ease of expanding into an all IP Network.

 

AJ...You may correct me if i'm wrong....

 

Kris

  • Like 3
Link to comment
Share on other sites

And just as a refresher....SMS/MMS over LTE is possible by a thing called, "Message Transfer over IMS" (IP Multimedia Subsystem). The functionality of this is to provide legacy "Switched" services over an IP Network (ie. LTE). The IMS can be used for Voice, SMS, MMS, etc. by sending them over an IP Link from the UE (User Equipment/Handest) to a gateway. Then the gateway converts it back to a "Circuit Switched" service back at the MSC (or wherever the IMS Gateway is for Sprint). Right now Sprint is only using this for SMS/MMS, but it can and will be utilized for the transition from "Circuit Switched Voice" to VoLTE to connect back to the PSTN Network. This is why were still using eSCFB (FOR CALLS ONLY) think of the name... Circuit Switched FALL BACK (Falls back to the Circuit Switched network) for the call. eCSFB does not provide the SMS/MMS Link. It only switches you back to 3G For a Circuit Switched service that cannot be provided over IP.

 

Now for the IP Link, think of it like a SIP Link. It converts the SMS/MMS to a SIP type address and forwards it out to the gateway for processing. All done over IP. If you fall back to 3G/1x...then it goes back to the old Circuit Switched method...It was designed this way for seamless use while on LTE and for the ease of expanding into an all IP Network.

 

AJ...You may correct me if i'm wrong....

 

Kris

I think IMS is also what Sprint is using to support WI-Fi calling as well.

  • Like 1
Link to comment
Share on other sites

I think IMS is also what Sprint is using to support WI-Fi calling as well.

I would guess you are correct as WiFi calling is basically VoIP...But instead of going over LTE, It's over WiFi (Naturally...lol)

 

 

Sent from my iPad using Tapatalk

Link to comment
Share on other sites

I have never seen my phone drop LTE to send a text, it always stays on LTE and I have the phone on LTE mode instead of Global, 3G or 1x.

 

it is confusing, but there are 2 completely different 'lte modes'.

 

One is the one you refer to with global/lte/3g, the other is in the advanced settings which require your MSL and dialer code to access (LTE ONLY).

 

the standard lte/global does not affect SMS, where setting the advanced LTE ONLY can affect sms and calls.

  • Like 1
Link to comment
Share on other sites

it is confusing, but there are 2 completely different 'lte modes'.

 

One is the one you refer to with global/lte/3g, the other is in the advanced settings which require your MSL and dialer code to access (LTE ONLY).

 

the standard lte/global does not affect SMS, where setting the advanced LTE ONLY can affect sms and calls.

Oh I got you I was mildly confused. [emoji12]

 

Sent from my Nexus 5

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • A heavy n41 overlay as an acquisition condition would be a win for customers, and eventually a win for T-Mobile as that might be enough to preclude VZW/AT&T adding C-Band for FWA due to spreading the market too thinly (which means T-Mobile would just have local WISPs/wireline ISPs as competition). USCC spacing (which is likely for contiguous 700 MHz LTE coverage in rural areas) isn't going to be enough for contiguous n41 anyway, and I doubt they'll densify enough to get there.
    • Boost Infinite with a rainbow SIM (you can get it SIM-only) is the cheapest way, at $25/mo, to my knowledge; the cheaper Boost Mobile plans don't run on Dish native. Check Phonescoop for n70 support on a given phone; the Moto G 5G from last year may be the cheapest unlocked phone with n70 though data speeds aren't as good as something with an X70 or better modem.
    • Continuing the USCC discussion, if T-Mobile does a full equipment swap at all of USCC's sites, which they probably will for vendor consistency, and if they include 2.5 on all of those sites, which they probably will as they definitely have economies of scale on the base stations, that'll represent a massive capacity increase in those areas over what USCC had, and maybe a coverage increase since n71 will get deployed everywhere and B71 will get deployed any time T-Mobile has at least 25x25, and maybe where they have 20x20. Assuming this deal goes through (I'm betting it does), I figure I'll see contiguous coverage in the area of southern IL where I was attempting to roam on USCC the last time I was there, though it might be late next year before that switchover happens.
    • Forgot to post this, but a few weeks ago I got to visit these small cells myself! They're spread around Grant park and the surrounding areas, but unfortunately none of the mmwave cells made it outside of the parks along the lake into the rest of downtown. I did spot some n41 small cells around downtown, but they seemed to be older deployments limited to 100mhz and performed poorly.    
    • What is the cheapest way to try Dish's wireless network?  Over the past year I've seen them add their equipment to just about every cell site here, I'm assuming just go through Boost's website?  What phones are Dish native?  
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...