Student Posted February 5, 2014 Share Posted February 5, 2014 Hi, So the airave 2.5 has been working flawlessly for almost 2 years. All of a sudden the Red mobile light blinks and the phones don't connect. All others are green. Anyone ever see this? Once 800mhz is active in the area it won't be needed but until then... I'm wondering if sprint disconnected it as they're finishing network vision? Sent from my SPH-L710 using Tapatalk Quote Link to comment Share on other sites More sharing options...
Destroyallcubes Posted February 5, 2014 Share Posted February 5, 2014 They don't disconnect it. Have you tried resetting the airave. There should be a pin hole to push in. Quote Link to comment Share on other sites More sharing options...
SeanK_ Posted February 5, 2014 Share Posted February 5, 2014 They don't disconnect it. Have you tried resetting the airave. There should be a pin hole to push in. This would be your best bet, the last time I had this light flashing was with the Network and it happened to be a Sprint outage. I would also put the Airave behind your DMZ on your network and reset the device. Not sure what the IP address would be, but you would have to find that out. If that doesn't work, call the Airave Department. Quote Link to comment Share on other sites More sharing options...
miguell2 Posted February 5, 2014 Share Posted February 5, 2014 Resetting it is your best bet. Quote Link to comment Share on other sites More sharing options...
Destroyallcubes Posted February 5, 2014 Share Posted February 5, 2014 Also if the reset does not work. Turn the airave off over night and turn it back on in the morning. That usually works when mine goes haywire Quote Link to comment Share on other sites More sharing options...
hescominsoon Posted February 6, 2014 Share Posted February 6, 2014 Hi, So the airave 2.5 has been working flawlessly for almost 2 years. All of a sudden the Red mobile light blinks and the phones don't connect. All others are green. Anyone ever see this? Once 800mhz is active in the area it won't be needed but until then... I'm wondering if sprint disconnected it as they're finishing network vision? Sent from my SPH-L710 using Tapatalk known issue with the gps system. if it looses gps or it's not clear(or the gps unit fails) that will happen. However if ONLY the mobile is blinking then most likely your airave has died. IME they are goo for 1-2 years then they go poofies. Call up the airave team for a replacement after they have you jump through some troubleshooting hoops to prove it's dead jim.. Quote Link to comment Share on other sites More sharing options...
Student Posted February 6, 2014 Author Share Posted February 6, 2014 Thanks guys, the airave is set as dmz with static ip address. I'll try the overnight thing, but i'm thinking you are all right it's gone toast can't wait until 800mhz rolls out here thanks! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.