Jump to content

Sprint's first quarter financials are out


marioc21

Recommended Posts

One little piece of data from the earnings call:

 

Further, in the 600 network Vision sites currently online, Elfman said Sprint is seeing a doubling of the coverage range compared with legacy sites, which should help reduce roaming costs. Sprint is also able to repurpose 2.5 MHz to 3 MHz of spectrum on its 800 MHz band from Nextel iDEN service to voice, he said.

  • Like 1
Link to comment
Share on other sites

One little piece of data from the earnings call:

 

Further, in the 600 network Vision sites currently online, Elfman said Sprint is seeing a doubling of the coverage range compared with legacy sites, which should help reduce roaming costs. Sprint is also able to repurpose 2.5 MHz to 3 MHz of spectrum on its 800 MHz band from Nextel iDEN service to voice, he said.

 

 

I heard that on the conference call but couldn't type it up fast enough. Then they moved on and I couldn't remember exactly what they'd said.

Link to comment
Share on other sites

This is slightly misleading. They may be seeing a coverage doubling on NV 800 CDMA compared to legacy 1900 CDMA. Since they are not deploying EVDO on 800, this is 1x only.

 

However, they are not seeing those kinds of gains between NV 1900 CDMA and legacy 1900 CDMA. That gain is not 100%, it is approximately 20% gain between the two.

 

Robert - Posted from my E4GT with ICS using Forum Runner

Link to comment
Share on other sites

Robert,

I would expect that between the mounting of the radios on the antenna masts and the 1x Advanced up to 70% increase in coverage primarily because of interference cancellation, they might be close to doubling of the coverage area, all other things being equal (downtilt, power, etc). Now if they are not skipping any legacy CDMA sites in their deployment, they probably are turning down the power, thereby cancelling out some of the coverage improvements.

 

For CDMA800 they are using 1x Advanced's up to 3x capacity improvement and not trading off for distance. If they

Link to comment
Share on other sites

My comments are not based on guesses. They are based on reports from Sprint's FIT's. The gains are approximately 20% in field testing from legacy to NV on 1900 CDMA. And from our members who have used NV sites, this seems to be substantiated. There are no wonderful sudden gains in coverage occurring.

 

Due to downtilt at most sites, the gains will not be in coverage area, but in stronger signal. Only at sites at the periphery of existing coverages (rural areas) can you adjust the downtilit up to try to capture the 20% coverage gain.

 

Robert - Posted from my E4GT with ICS using Forum Runner

  • Like 1
Link to comment
Share on other sites

There won't be any coverage gains in areas that are already covered well and were you do not adjust downtilt. There will be coverage improvements in cases were you were on the fringe of usuable signal and now you won't be. There will be an expansion of the "usable" coverage area. RF limits are RF limits and propagation is propagation but usable signal is something all-together. Outward facing sectors on the periphery of a coverage area can have the downtilt adjusted and their usable signal area expanded quite a bit. I also consider the thickening of coverage on the interior of a coverage area a tangible benefit, as in the increase of the percentage of the coverage area in which you get "Good" or "Excellent" signal instead of "Fair". I think that maybe that's what he's talking about. That instead of 50% of a heavily suburban area like Atlanta or Dallas being "Light Green" in the signal maps, only 25% is after NV 1900MHz. Add 800MHz NV and only 5% is light green, all this with no additional sites.

Link to comment
Share on other sites

Robert,

I would expect that between the mounting of the radios on the antenna masts and the 1x Advanced up to 70% increase in coverage primarily because of interference cancellation, they might be close to doubling of the coverage area, all other things being equal (downtilt, power, etc). Now if they are not skipping any legacy CDMA sites in their deployment, they probably are turning down the power, thereby cancelling out some of the coverage improvements.

 

For CDMA800 they are using 1x Advanced's up to 3x capacity improvement and not trading off for distance. If they

 

I would much rather have Sprint configure the 1x Advanced 1900 MHz carriers to support 4x capacity so they can shut down more 1x carriers. The towers are located to account for 1900 MHz anyways so its better to max out more voice capacity to free up more spectrum for LTE. Now there are placed like in New Orleans were it makes sense to use the 70% coverage since the towers are not strategically located. CDMA800 no doubt does not need the 70% extra coverage and instead needs to max out 4x capacity especially if its going to handle indoor voice calls.

Link to comment
Share on other sites

There won't be any coverage gains in areas that are already covered well and were you do not adjust downtilt. There will be coverage improvements in cases were you were on the fringe of usuable signal and now you won't be. There will be an expansion of the "usable" coverage area. RF limits are RF limits and propagation is propagation but usable signal is something all-together. Outward facing sectors on the periphery of a coverage area can have the downtilt adjusted and their usable signal area expanded quite a bit. I also consider the thickening of coverage on the interior of a coverage area a tangible benefit, as in the increase of the percentage of the coverage area in which you get "Good" or "Excellent" signal instead of "Fair". I think that maybe that's what he's talking about. That instead of 50% of a heavily suburban area like Atlanta or Dallas being "Light Green" in the signal maps, only 25% is after NV 1900MHz. Add 800MHz NV and only 5% is light green, all this with no additional sites.

 

Thank you for agreeing with me. This is what I said right above your comment. However, my chief point stands that the comment made will mislead many into believing that double the coverage gain comes from 1900 CDMA alone, when in reality that coverage gain stated is the difference between legacy 1900 and NV 800. That's what we do here at S4GRU, clarify and inform. Much better than Sprint does, I might add.

 

Robert

  • Like 1
Link to comment
Share on other sites

I would much rather have Sprint configure the 1x Advanced 1900 MHz carriers to support 4x capacity so they can shut down more 1x carriers. The towers are located to account for 1900 MHz anyways so its better to max out more voice capacity to free up more spectrum for LTE. Now there are placed like in New Orleans were it makes sense to use the 70% coverage since the towers are not strategically located. CDMA800 no doubt does not need the 70% extra coverage and instead needs to max out 4x capacity especially if its going to handle indoor voice calls.

 

I have asked all my sources this question, and most glaze over. However, I did have one Samsung RF Engineer tell me that they are configuring all 1xA carriers differently based on location. Urban sites will be deployed for capacity gains. Rural sites will be deployed for coverage gain. So there will be a lot of variability. We have detailed information about the deployment of every single Sprint site in the country. I wish it also contained 1xA configuration info.

 

Robert

  • Like 1
Link to comment
Share on other sites

I would much rather have Sprint configure the 1x Advanced 1900 MHz carriers to support 4x capacity so they can shut down more 1x carriers. The towers are located to account for 1900 MHz anyways so its better to max out more voice capacity to free up more spectrum for LTE. Now there are placed like in New Orleans were it makes sense to use the 70% coverage since the towers are not strategically located. CDMA800 no doubt does not need the 70% extra coverage and instead needs to max out 4x capacity especially if its going to handle indoor voice calls.

 

On top of what Robert said, most suburban/exurban sites have 1 to maybe 2 voice channels. The spectrum reclaimed will not be substantial. As Robert already said, Urban sites will be configured for capacity gains. In my hometown I have rarely seen more than one voice channel. They could probably serve us out of one 1x 800MHz channel every other site. That might not be true in other areas that have more Sprint subscribers per square mile, but I do believe it to be true of our area.

  • Like 1
Link to comment
Share on other sites

 

On top of what Robert said' date=' most suburban/exurban sites have 1 to maybe 2 voice channels. The spectrum reclaimed will not be substantial. As Robert already said, Urban sites will be configured for capacity gains. In my hometown I have rarely seen more than one voice channel. They could probably serve us out of one 1x 800MHz channel every other site. That might not be true in other areas that have more Sprint subscribers per square mile, but I do believe it to be true of our area.[/quote']

 

Same here in rural New Mexico.

 

Robert - Posted from my E4GT with ICS using Forum Runner

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...