Jump to content

FreedomPop WiMAX coverage different than Sprint WiMAX coverage?


rwong48

Recommended Posts

For those who don't know, FreedomPop launched their free service not too long ago with Sprint/Clear's WiMAX network (please correct me if I'm wrong.) http://slickdeals.ne...h-49-99-deposit

 

I'm in an area with generally weak WiMAX outside, and usually none inside. In particular, it's not available at my workplace (indoors nor outdoors). I've tried this with my EVO Shift and a coworker's EVO Design.

 

However, the FreedomPop device gets a great signal and great speeds (7-9Mbps down, 1-1.5Mbps up). I thought they were both running on the same network.. does anyone know what's going on here?

Link to comment
Share on other sites

Coverage is definitely not different. I bet the Freedom POP device has a much stronger radio. This was definitely noticeable with some WiMax hotspots being vastly superior to the EVO.

 

Robert via Moto Photon Q using Forum Runner

Link to comment
Share on other sites

Thanks guys. I figured there may have been some radio difference, but not to the extent of "great" vs "zero" coverage outdoors where I am.

 

What device are you comparing the Evo Design and Shift to? Perhaps it has better radios...

I'm using the Freedom Spot Photon (portable hotspot). Basically the same as the Clear Spot Voyager.

Link to comment
Share on other sites

Thanks guys. I figured there may have been some radio difference, but not to the extent of "great" vs "zero" coverage outdoors where I am.

 

 

I'm using the Freedom Spot Photon (portable hotspot). Basically the same as the Clear Spot Voyager.

 

...and that, to be honest, is a weak WiMAX hotspot. Though it's mobile. I swapped mine for a Clear desktop modem and both reception and data speeds are much better on the much (MUCH) larger device :)

  • Like 1
Link to comment
Share on other sites

Thanks guys. I figured there may have been some radio difference, but not to the extent of "great" vs "zero" coverage outdoors where I am.

 

The maximum threshold for WiMax is around -85dBm RSSI for most smartphones (some were even limited to -82dBm). So if you were getting between -82dBm and -85dBm on your previous WiMax device, then you likely had pretty mediocre service that didn't want to stay connected. If your new device is getting even just -78dBm to -80dBm, the difference would be night and day.

 

If you think about a conventional WiMax deployment, there were so many places where you didn't think you had a signal, but you did, but it was too weak for you to know it was there. Each site had dozens or even hundreds of square miles with -85dBm to -95dBm signals that your device did not detect. If you had a stronger radio, a good portion of these no signal areas could now be live to you.

 

Robert

  • Like 1
Link to comment
Share on other sites

  • 7 months later...

Figured I might resurrect this thread instead of posting somewhere else erroniously.

 

Does anyone know if Freedompop customers have access to Clear protection sites? I am getting the Overdrive to have some cheap data in the car for my iPad on the EvDO side of Freedompop for $4.

 

Still would be nice to have access to WiMax at home, which is served by a protection site.

Link to comment
Share on other sites

Does anyone know if Freedompop customers have access to Clear protection sites

 

Yes they do. I am able to connect to the protection sites here in Arizona with my Freedompop account.

 

 

Sent from my iPhone 5 using Tapatalk

  • Like 1
Link to comment
Share on other sites

  • 5 months later...

Can you explain? What is a protection site? I am a Clear user.

 

 

Sent from my iPod touch using Tapatalk

They were WiMax "islands" sites setup just to cover population to protect the license from being pulled by the FCC.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...