Jump to content

Network Vision/LTE - Tampa Market


Feech

Recommended Posts

Looks like there might be a new tower online. Just picked up LTE in my house off of mullis city way and gunn hwy. either that or they REALLY adjusted the down tilt on the one in circus part. I doubt it could ever make it this far.

Link to comment
Share on other sites

 

 

I suppose they may have upped the rescan a bit since I hear some complaints about battery life. I haven't noticed a drop off in "connect-ability" though.

It stayed connected, but in order for it to connect to LTE I had to put it in airplane mode. I think before it was every 5 seconds it scanned, it might be 5 minutes now.

Link to comment
Share on other sites

It stayed connected, but in order for it to connect to LTE I had to put it in airplane mode. I think before it was every 5 seconds it scanned, it might be 5 minutes now.

 

Don't want to tun this into a EVO thread but the timing change might be for the best. Its seems my phone right now in deployment stage gets confused when it is between coverages

Link to comment
Share on other sites

I stopped by the Lynn site off of Gunn hwy to see if that's where the LTE signal at my house was coming from. There was a unmarked service truck there. I spoke to one of the guys, he said all the ground work was done and another team is going to come soon to put the panels up.

Link to comment
Share on other sites

I'll pass through the Waters/Dale Mabry area around 5:30. If nobody else has reported anything by then, I'll let you know what I find.

 

Thanks to (another) crash on the Howard Frankland this afternoon, I diverted to the Gandy Bridge. Picked up 4G on the Tampa side of Gandy, and up Dale Mabry, past Britton Plaza (to about El Prado). According to the LTE Discovery app, I was getting an occasional "blip" of LTE, as I continued north, via Himes. Nothing north of Kennedy.

 

Sensorly was also running the whole time, except for the airplane mode cycles prompted by LTE Discovery.

 

Oh, and regarding LTE Discovery: This morning's update seems to have fixed the GPS reporting. The coordinates list looks MUCH better now.

  • Like 1
Link to comment
Share on other sites

The thing I dislike about using LTE discovery with Sensorly is when people leave it on to continue to cycle after it finds a LTE signal. It makes it look like moorse code on Sensorly and you can't tell if its a new site or an exiting one because it doesn't have enough time to map before airplane mode comes back on. If our market had only a couple towers you would see its a new hit, but with all the towers coming online here, it can be any exiting tower making a mark on Sensorly.

Link to comment
Share on other sites

The thing I dislike about using LTE discovery with Sensorly is when people leave it on to continue to cycle after it finds a LTE signal. It makes it look like moorse code on Sensorly and you can't tell if its a new site or an exiting one because it doesn't have enough time to map before airplane mode comes back on. If our market had only a couple towers you would see its a new hit, but with all the towers coming online here, it can be any exiting tower making a mark on Sensorly.

If I'm watching the screen, I'll disable it when I see that I'm in 4G territory, and restart when I lose it. But if I'm unable to watch what's happening, I figure it's better to mark at least some of the coverage, instead of none at all. If I blaze a broken trail, someone else will know where to go, to fill in the holes.

Link to comment
Share on other sites

Suncoast parkway in citrus park? If you mean the veterans express way, I thought that was already mapped.

 

Nope... I was mapping earlier in Spring Hill, on my way to Brooksville. I mapped down the Suncoast on the way back. Then made a loop around Citrus Park, as there were spots not on the map there. I made a quick post while driving. Sorry for any confusion... ;)

 

Also, I'll choose a route to get somewhere that isn't mapped if at all possible. I work all over the state at times & I map whenever I can...

 

Sent from my Galaxy S III

 

 

Link to comment
Share on other sites

The thing I dislike about using LTE discovery with Sensorly is when people leave it on to continue to cycle after it finds a LTE signal. It makes it look like moorse code on Sensorly and you can't tell if its a new site or an exiting one because it doesn't have enough time to map before airplane mode comes back on. If our market had only a couple towers you would see its a new hit, but with all the towers coming online here, it can be any exiting tower making a mark on Sensorly.

 

SpenceSouth works for the company that created that app. I've requested they add a feature that would only start a search (by cycling Airplane mode) when LTE is lost. The current Auto Search feature isn't as useful to me, as I want to stay on LTE as long as possible while mapping. And, in fringe areas, it is inevitable that you will loose and have to reaquire an LTE connection while mapping. Going behind obstructions, over hills, etc all affect this to some extent. As a result, this will cause the morse code like mapping at the edges...

 

Sent from my Galaxy S III

 

 

Link to comment
Share on other sites

 

 

SpenceSouth works for the company that created that app. I've requested they add a feature that would only start a search (by cycling Airplane mode) when LTE is lost. The current Auto Search feature isn't as useful to me, as I want to stay on LTE as long as possible while mapping. And, in fringe areas, it is inevitable that you will loose and have to reaquire an LTE connection while mapping. Going behind obstructions, over hills, etc all affect this to some extent. As a result, this will cause the morse code like mapping at the edges...

 

Sent from my Galaxy S III

That's a good idea!

  • Like 1
Link to comment
Share on other sites

I'll pass through the Waters/Dale Mabry area around 5:30. If nobody else has reported anything by then, I'll let you know what I find.

 

Thanks to (another) crash on the Howard Frankland this afternoon, I diverted to the Gandy Bridge. Picked up 4G on the Tampa side of Gandy, and up Dale Mabry, past Britton Plaza (to about El Prado). According to the LTE Discovery app, I was getting an occasional "blip" of LTE, as I continued north, via Himes. Nothing north of Kennedy.

 

Sensorly was also running the whole time, except for the airplane mode cycles prompted by LTE Discovery.

 

Oh, and regarding LTE Discovery: This morning's update seems to have fixed the GPS reporting. The coordinates list looks MUCH better now.

I'm at the waters/dale mabry site right now. No LTE broadcasting here. Definitely has 3 sprint LTE panels up, 1 on each side.
Link to comment
Share on other sites

I'm at the waters/dale mabry site right now. No LTE broadcasting here. Definitely has 3 sprint LTE panels up, 1 on each side.

I go to church literally right across the street on Dale Mabry and Waters and I always check that tower. I will keep a lookout.

Link to comment
Share on other sites

 

 

Nope... I was mapping earlier in Spring Hill, on my way to Brooksville. I mapped down the Suncoast on the way back. Then made a loop around Citrus Park, as there were spots not on the map there. I made a quick post while driving. Sorry for any confusion... ;)

 

Also, I'll choose a route to get somewhere that isn't mapped if at all possible. I work all over the state at times & I map whenever I can...

 

Sent from my Galaxy S III

Awesome! Thanks. Did you go down Gunn Hwy?
Link to comment
Share on other sites

The thing I dislike about using LTE discovery with Sensorly is when people leave it on to continue to cycle after it finds a LTE signal. It makes it look like moorse code on Sensorly and you can't tell if its a new site or an exiting one because it doesn't have enough time to map before airplane mode comes back on. If our market had only a couple towers you would see its a new hit, but with all the towers coming online here, it can be any exiting tower making a mark on Sensorly.

 

Just wait until the next update. Got something planned that will remedy that and everyone will like ;)

 

Sent from my Nexus 7 using Tapatalk HD

  • Like 2
Link to comment
Share on other sites

Awesome! Thanks. Did you go down Gunn Hwy?

 

I think I might have. That, along with a bunch if random streets in the area. I also have been mapping randomly around the tower at Dale Mabry & Van Dyke and the tower in Wesley Chapel when I have time. The maps on Sensorly should start to reflect all of this soon...

 

Sent from my Galaxy S III

 

 

Link to comment
Share on other sites

I'm at the waters/dale mabry site right now. No LTE broadcasting here. Definitely has 3 sprint LTE panels up, 1 on each side.

 

I took pictures of that tower several weeks ago, soon after New Years. At the time, it had the 4G panels & RRUs. There was also someone onsite working on or inspecting the tower.

 

Sent from my Galaxy S III

 

 

Link to comment
Share on other sites

Hello all. I mapped in SR52 @ I75 this morning. I was getting unusually fast download speeds and was able to go way East from there. Now that I look at my uploaded Sensorly Data, there appears to be a new 4G LTE tower just East of the SR52/I75 intersection...

 

Sent from my Galaxy S III

 

 

Link to comment
Share on other sites

The thing I dislike about using LTE discovery with Sensorly is when people leave it on to continue to cycle after it finds a LTE signal. It makes it look like moorse code on Sensorly and you can't tell if its a new site or an exiting one because it doesn't have enough time to map before airplane mode comes back on. If our market had only a couple towers you would see its a new hit, but with all the towers coming online here, it can be any exiting tower making a mark on Sensorly.

Well I look forward to the update as I don't have a choice but to use cycling when mapping and I'm on the motorcycle (for obvious reasons).

Link to comment
Share on other sites

Hello all. I mapped in SR52 @ I75 this morning. I was getting unusually fast download speeds and was able to go way East from there. Now that I look at my uploaded Sensorly Data, there appears to be a new 4G LTE tower just East of the SR52/I75 intersection...

 

Sent from my Galaxy S III

Cool. Sensorly has been taking a long time to update lately. Some zoom levels haven't updated in five days like south Tampa. I wonder if there is a cache on our phones that stores the maps that can be deleted so the info is fresh?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...