Jump to content

VoLTE Chip


legion125

Recommended Posts

Migrated from Original Forum. Originally Posted 2 February 2012

 

Here's some information on Qualcomm's new chip to satisfy the inner geek in us and this technology has been discussed in other threads and forums as being under development, now its a reality. This design allows the hand off from a GSM network to VoLTE and back. Obviously its a multi-mode single chip design that eliminates the need of another modem in the phone. This is a first step and I'm sure CDMA is not far behind.

 

 

Qualcomm's Snapdragon on track for Voice over LTE

Qualcomm, along with Ericsson, has successfully completed a major hurdle that will enable Voice-over-LTE (VoLTE).

The technology, called Single Radio Voice Call Continuity, or SRVCC, enables continuity of service by seamlessly switching to a WCDMA network when a consumer on a VoLTE call leaves the LTE network's coverage area, Qualcomm said.

Qualcomm and Ericsson have completed the first voice call handover from an LTE mobile network to a WCDMA network using SRVCC.

A Snapdragon-powered Ericsson device, using Qualcomm's Snapdragon S4 MSM8960 3G/LTE multimode processor, will be on demonstration at Qualcomm's Mobile World Congress booth, Qualcomm said.

Ultimately the goal is to have one less modem chip to worry about and therefore slimmer, less power-hungry LTE phones.

And how is this achieved? An acronym-packed backgrounder is provided by Qualcomm.

"SRVCC is the next logical step in...4G LTE voice...following the commercial launch of circuit-switched fallback technology (CSFB) on smartphones in 2011. Circuit-switched fallback technology (CSFB) allows a single radio in the handset to dynamically switch from an LTE data connection to a 3G connection when the user needs to make or receive a call. Similarly, SRVCC support enables a single radio in the handset to execute a seamless handover of a voice call from an LTE network to a 3G network."

And SRVCC and CSFB allow both LTE and 3G network connections to be supported on a single chip. The upshot: no need for separate LTE and 3G radios and modems. And that means handsets with lower power consumption that are more compact--and have a lower component cost.

"This new development eliminates the need for a second modem chip, thereby reducing the cost and even size of future 4G/LTE handsets. Clearly, this will make future high-performance smartphones more attractive to consumers," said Will Strauss, president of Forward Concepts.

  • Like 1
Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 2 February 2012

 

VoLTE is coming! And interoperability with existing 3G and 2G networks will be essential. This is an exciting development. I remember reading about 3 or 4 years ago some naysayers said it was virtually impossible to handoff between VoLTE and existing voice networks, and that VoLTE networks would have to be stand alone. Boy, did they call that wrong! I love evolving technology.

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 3 February 2012

 

Agreed. The thing I'm looking forward to is how Sprint will reallocate all the spectrum it uses for 2&3G. With voice & data being on LTE, Sprint can do a lot with bldg penetration and area coverage with this free spectrum in areas were those needs are weak. However, it looks like Sprint will be the last of the group transitioning over to it since it looks like Metro PCS, Verizon and AT&t will beat them by a year or two.Migrated from Original Forum. Originally Posted 2 February 2012

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 3 February 2012

 

Verizon is supposedly working with OEM's now on on voice only VoLTE handsets and VoLTE feature phones. I think we are just about there.

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 4 February 2012

 

I was in batteries plus buying a 4 wheeler battery, and there was a lady buying a new battery for her 10+ year old nokia. People are going to react to VoLTE with anger at first. They are going to have to offer feature phones for free with free activation and ship them to some people.

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 4 February 2012

 

I think it will be ok, and more like the transition from analog to digital. Once VoLTE is out there will be an approx 3 year transition or maybe longer, so people that have older phones can fulfill contract obligations and then get a newer phone. Of course there are some who like hanging on to their phones forever, but eventually they will have to join the 21st century.

I don't know if the carriers will make accommodations or not. When TV made the switch to digital most waited until the last minute before buying their converters or getting a new set. They just cried all the way to the store, but it got done.

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 5 February 2012

 

I was talking to my brothers in law last night at the basketball game and none of them had any idea what LTE or VoLTE is. When I said it is coming in 2013 and they will eventually have to upgrade their phones. 2 have iphones and the other has an Evo. The two with the iPhones were not pleased with the upgrade requirement. That market could be more difficult to transfer over than the feature phones. IPhones are expensive, even with an upgrade, and Verizon just started carrying the iPhone, so there are a lot of customers with newish iPhones that will not be happy with a mandate to upgrade. Who knows, maybe by that time the iPhone 5 will be free with upgrade like how AT&T offers the 3GS...

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 5 February 2012

 

It will certainly be a carrier at a time doing the VoLTE transition, but I recall when the carriers where migrating from analog to digital the analog network was up for years before it was finally shut down, and it affected a only a few who stubbornly held on to their analog phones. I think we will hear more when Metro PCS and Verizon begin to take VoLTE seriously and see what their timelines say.

Link to comment
Share on other sites

Migrated from Original Forum. Originally Posted 5 February 2012

 

I am curious why everyone is so agog over VoLTE. Certainly, the prospect of ubiquitous mobile VoIP is, at least technologically speaking, an interesting paradigm shift. But do we really expect an enhanced end user experience from VoLTE? CDMA1X spreading gain, soft handoff, and noise suppression make it almost ideally suited to moderate bit rate voice transmission. So, VoLTE has a high standard to follow.

 

AJ

Link to comment
Share on other sites

 

I am curious why everyone is so agog over VoLTE. Certainly, the prospect of ubiquitous mobile VoIP is, at least technologically speaking, an interesting paradigm shift. But do we really expect an enhanced end user experience from VoLTE? CDMA1X spreading gain, soft handoff, and noise suppression make it almost ideally suited to moderate bit rate voice transmission. So, VoLTE has a high standard to follow.

 

AJ

 

I think some carriers are excited about a single technology network where all frequency is being utilized at maximum spectral efficiency. Verizon certainly is aiming for an all LTE network at warp speed ahead.

 

I think in the case of Verizon, they want an all LTE network for simplicity and cost savings. And the ability to repurpose all its existing spectrum to LTE as soon as they can reasonable force its customers to migrate.

 

In the case of MetroPCS, I think they are so deseperate for LTE spectrum, that they desperately need to use its 1x spectrum for LTE. So why not kill two birds with one stone?

 

I don't advocate that these are the best solutions necessarily. But I can see why these two carriers are pursuing it so readily.

 

VoLTE is going to be interesting to watch deploy and mature.

 

Sent from Tapatalk App

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...