Jump to content

Do cell boosters work?


boomerbubba

Recommended Posts

What is the informed consensus about cell RF boosters for buildings and vehicles?

 

I'm referring to a general configuration of products with an external antenna, an internal antenna and a Tx/Rx amplifier in between.

 

Do these work, and if so how? Can they just amplify all the RF traffic within the entire bands they cover? I notice some vehicle products advertised to work on the 800 and 1900 Mhz bands.

Link to comment
Share on other sites

What type of Internet Connection does a signal booster requires?

 

None.

 

AJ

Link to comment
Share on other sites

What signal booster would be good for a 5000 SQ FT Area?

Link to comment
Share on other sites

Does the repeater technology really just amplify everything (all RF signals and noise) across the entire bands that are covered? So there is no dependency upon the communications protocol -- GSM, CDMA, LTE, etc?

Link to comment
Share on other sites

Still researching this topic, especially focused on whether the booster-repeaters now on the market would support Sprint's forthcoming LTE service. (I'm interested in areas of marginal coverage in West Texas, which I occasionally traverse.)

 

I contacted Wilson Electronics, which seems to be the market leader in this field, and asked specifically about support for Sprint LTE. (Wilson already advertises certain products targeting Verizon and AT&T LTE.) The response indicated that compatible products are on the drawing boards:

 

.. while we are developing products for LTE for the carriers, it is not based on the protocols but on the frequencies they are using. Verizon is using a specific band of the 700 MHz and AT&T is using a different band. Sprint will be using the 1900 MHz but it is slightly off the frequencies our amplifiers now cover. Hopefully that will be resolved in the near future. That is why they are labeled specific to the carrier.

 

We are working on increasing our products for the frequencies the carriers will be using. Unfortunately we don’t have an estimated time of completion.

 

So I will keep an eye on this. There does not seem to be any immediate danger that Sprint's NV buildout will reach the West Texas market (or El Paso, which is west of West Texas) anyway. I doubt that I would need any booster where I actually live in Central Texas.

Link to comment
Share on other sites

Don't forget the 800Mhz that will be used starting next year for LTE should provide better coverage for the fringe areas if you are able to get a decent signal outside at this point you may end up wasting your money. If you can't get decent signal even outside than a booster may not be for you anyway an amplifier can only increase the signal it receives and adds noise in the process so signal quality on the back end will be less than that received even if the power is higher.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...