Search the Community
Showing results for tags '8x8 2500'.
Found 2 results
Tim YuSprint 4G Rollout UpdatesJanuary 26, 2018 - 5:30 AM PST [Edited: 1/28/18 to include additional information on Samsung 4 port 800 MHz radio] [Edited: 2/2/18 for photograph addition of an Ericsson setup] The Triband Hexadecaport. The newest development of Sprint's recent network expenditures. This is a new triband antenna configuration now being deployed by Sprint that is able to do 4T4R MIMO on both 800 MHz and 1900 MHz in addition to 8T8R MIMO over 2.5 GHz. All in one single antenna. Previously, Sprint typically utilized two different antennas with one from Network Vision days being a hexport dual band unit that supports 800 MHz and 1900 MHz. While 2.5 GHz was an additional antenna and radio unit added on later. Some sites utilized (and may continue to utilize) another triband antenna model. This older generation triband antenna is a decaport (10 port) triband unit that support 4T4R on both 1900 MHz and 2.5 GHz with 2T2R on 800 MHz. This meant that an 8T8R radio would have its capabilities decreased as a result of going from 8T8R to 4T4R. With the development and deployment of this new 16 port triband antenna, Sprint is now poised to offer 800 MHz 4 antenna transmit and receive diversity alongside 1900 MHz, while 2.5 GHz is able to fully utilize the capability of an 8T8R radio. This means that the full capability of Sprint's 800 MHz, 1900 MHz, and LTE Plus (2.5 GHz) network can be utilized from a single triband antenna panel. Removing the limitations of the previous go-to triband antenna model. Because of these limitations, Sprint did not deploy the previous triband antenna panel in a wide scale. Now they are likely to deploy these more commonly. In fact, we are already seeing this occur in Washington State, Pittsburgh, and other places en masse. Above: Samsung 4T4R 800 MHz setup via two 800 MHz RRH-C2, 4T4R 1900 MHz RRH-P4 , & 8T8R 2.5 GHz RRH-V3 Photograph Source: Josh (ingenium) Currently, this type of setup has been found in Samsung vendor regions with two individual 2T2R 800 MHz RRUs to achieve 4T4R MIMO. Samsung and Sprint has a new 4 port 4T4R 800 MHz RRU that will be able to do the job of two existing 2T2R 800 MHz RRUs that will be deployed alongside this new type of antenna. This new Samsung 4 port low frequency radio is also available in Band 13 750 MHz for deployment in the Puerto Rico market due to the Sprint Open Mobile deal. Photograph Source: Chris92 Ericsson Setup Source: mdob07 This type of setup is yet to be seen in Ericsson or Nokia - Alcatel-Lucent territory. If you discover these in other vendor regions, be sure to post about it! ****If you're in Ericsson or Nokia / former Alcatel-lucent territory then replace the Samsung radios with the relevant Nokia, Alcatel-Lucent CDMA / LTE and Ericsson radios depending on region.***
Dave YeagerSprint 4G Rollout UpdatesTuesday, April 3, 2018 - 6:20 PM PDT Exciting times for those of us who track Sprint Macro sites and signals. Sprint has accomplished a lot during the last few years in many places. Even during a period of reduced capital expenditures. Progress has been made by increasing bandwidth and adding carriers to LTE 1900 MHz, adding LTE 2.5 GHz macro and small cell sites, adding 3x3 LTE 800 MHz to many existing sites near the border, and working to eliminate 3G Only Ground Mounted Radio sites by adding LTE in many places*. Some of these improvements have been offset by ever increasing data demands that have doubled every 18 months. For maximum gain, a new plan was needed...Next-Gen. Since late Fall 2017 Columbus S4GRU members have been tracking new permits in Ohio trying to figure out Sprint’s Next-Gen plans in detail. These permits soon made it obvious that multiple site configurations are involved. In late February / early March three Next-Gen sites were found in the Columbus Market. To ensure that these were not just isolated test sites, two identical Next-Gen sites were confirmed in the Cincinnati Market about a week ago. These are new antennas and are a different scenario than described in the prior S4GRU Wall Article on 16 port Triband Antennas. Note that these new antennas (center) are about the same size as the 1900/800 MHz dual band antennas, except thicker and cover 2.5 GHz / 800 MHz. There are 10 ports on the bottom, excluding the 4 AISG ports, for 8T8R 2.5 GHz and 2T2R 800 MHz (plus 2T2R 800 MHz from Network Vision antenna/RRH). The site diagrams from Connecticut list them as Commscope DT465B-2XR-V2, which matches our photos. These new antennas are combined with a 2.5 GHz 8T8R RRH and another 800MHz RRH (a few permits list just one 4 port 800 MHz RRH) and always been found with existing hexport dual band 800/1900 MHz equipment. ** Sprint’s desire to add 2.5 GHz to all sites is well publicized. But why two 800 MHz RRHs? To allow 4x4 MIMO for 800 MHz LTE. While only some tablets will fully benefit from 4x4 MIMO given the antenna size requirements, all devices will benefit from the significant signal propagation and stability improvements over 2xT/R diversity. At the cell edge this is especially true. This will be a major improvement for technologies such as VoLTE where weak signals can wreak havoc on voice quality and even usability. Four Sprint scenarios were noted in some of the Connecticut information. Besides the two scenarios covered in this and the prior wall article, there is a ground mounted radio scenario, which is dated February 28, 2018 -- well past the changeover to Next-Gen antennas seen in the late Fall 2017 permits. Only the Triband decaport (10 port Antenna) is visible in the tower with diplexers and RRHs near the ground providing only 2T2R for 800MHz, 2T4R for the 1900MHz and 4T4R for the 2.5GHz, as shown below: *** *** Below is the current status of our 2017+ permits for the Columbus market to give you an idea of where these antenna scenarios will be used more often. Note that while there is extensive permit information for the Columbus market, not all jurisdictions put permit information online plus accuracy and detail varies. There is at least one Sprint Next-Gen Scenario remaining. Keep watching your local sites, especially if you see improved Band 26 LTE 800 or new Band 41 LTE 2500 signal or GCIs. Report anything new to a S4GRU forum. Include pictures and screen shots. Others will guide you to help figure out what you have found. *For details for my market for 2017: http://s4gru.com/forums/topic/1904-network-visionlte-columbus-market/?page=219&tab=comments#comment-526696 Other spreadsheet markets in this region have similar stories to tell. ** Wiring Diagram source: http://www.ct.gov/csc/lib/csc/ems/east_windsor/southmainst/sprint/em-sprint-047-180126_filing_southmainst_eastwindsor.pdf page 61 of 66 *** Ground mounted Radio Scenario: http://www.ct.gov/csc/lib/csc/ems/stratford/hawleylane/sprint/em-sprint-138-180302_filing_hawleylane.pdf page 7 of 107 Many thanks to lilotimz and kineticman for their assistance with this article.