Jump to content

Cellmapper


RAvirani

Recommended Posts

1 hour ago, danlodish345 said:

AT&T over here shut down band 2 HSPA

Sent from my Pixel 2 XL using Tapatalk
 

AT&T generally only shuts down Band 2 HSPA in areas where they have LTE deployed (in an effort to increase on-air LTE spectrum). In areas without LTE, AT&T usually runs several WCDMA/HSPA/HSPA+ carriers on both Bands 5 and 2. 

Link to comment
Share on other sites

2 hours ago, RAvirani said:

Yeah, but they usually are able to get away with that because most of their deployment is HSPA or HSPA+ which peaks at 21 or 42 mbps (depending on the configuration). That’s about the same as, if not better than, a 5x5 LTE carrier. 

I have not hit a dual carrier HSPA+ AT&T site in many years.  No more 42Mbps capable sites out there.  If you are on AT&T HSPA/HSPA+ only site with no LTE nearby, then they are typically very heavily used.  2-5Mbps in most instances I have observed.  It's only the HSPA+ colocated with LTE that typically runs really fast.  Because most of the traffic is on LTE in those instances.  Leaving FauxG wide open.

Link to comment
Share on other sites

2 minutes ago, S4GRU said:

I have not hit a dual carrier HSPA+ AT&T site in many years.  No more 42Mbps capable sites out there.  If you are on AT&T HSPA/HSPA+ only site with no LTE nearby, then they are typically very heavily used.  2-5Mbps in most instances I have observed.  It's only the HSPA+ colocated with LTE that typically runs really fast.  Because most of the traffic is on LTE in those instances.  Leaving FauxG wide open.

I think there are a few non-LTE dual carrier HSPA+ sites left in rural Montana and Utah...but generally speaking, you’re right. They are becoming rarer and rarer.

I’d say a majority of AT&T’s non-LTE areas today are probably 7.2 mbps WCDMA, which is not great, but gets the job done in most cases. 

Link to comment
Share on other sites

5 hours ago, RAvirani said:

AT&T generally only shuts down Band 2 HSPA in areas where they have LTE deployed (in an effort to increase on-air LTE spectrum). In areas without LTE, AT&T usually runs several WCDMA/HSPA/HSPA+ carriers on both Bands 5 and 2. 

yes now it its just band 5 over here... and i am curious as to when hspa will be shut down....AT&T is running 50 MHZ here...LTE 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Fury Gran Coupe (My First Car - What a Boat...)
    • Definite usage quirks in hunting down these sites with a rainbow sim in a s24 ultra. Fell into a hole yesterday so sent off to T-Mobile purgatory. Try my various techniques. No Dish. Get within binocular range of former Sprint colocation and can see Dish equipment. Try to manually set network and everybody but no Dish is listed.  Airplane mode, restart, turn on and off sim, still no Dish. Pull upto 200ft from site straight on with antenna.  Still no Dish. Get to manual network hunting again on phone, power off phone for two minutes. Finally see Dish in manual network selection and choose it. Great signal as expected. I still think the 15 minute rule might work but lack patience. (With Sprint years ago, while roaming on AT&T, the phone would check for Sprint about every fifteen minutes. So at highway speed you could get to about the third Sprint site before roaming would end). Using both cellmapper and signalcheck.net maps to hunt down these sites. Cellmapper response is almost immediate these days (was taking weeks many months ago).  Their idea of where a site can be is often many miles apart. Of course not the same dataset. Also different ideas as how to label a site, but sector details can match with enough data (mimo makes this hard with its many sectors). Dish was using county spacing in a flat suburban area, but is now denser in a hilly richer suburban area.  Likely density of customers makes no difference as a poorer urban area with likely more Dish customers still has country spacing of sites.
    • Mike if you need more Dish data, I have been hunting down sites in western Columbus.  So far just n70 and n71 reporting although I CA all three.
    • Good catch! I meant 115932/119932. Edited my original post I've noticed the same thing lately and have just assumed that they're skipping it now because they're finally able to deploy mmWave small cells.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...