Jump to content

T-Mobile LTE & Network Discussion V2


lilotimz

Recommended Posts

I could be wrong, but I feel very confident in saying that any AIR antennas would be those of either ATT or VZW, as Jacksonville is a Nokia infrastructure market.

 

I would imagine since Jacksonville is a late L700 market that T-Mobile may be going straight to NSN RAS, which affords 4T4R on L2100 and L1900, and 2T2R on L700.

 

 

Sent from my iPhone using Tapatalk

It's definitely a T-Mobile site for sure. I found it odd that Ericsson's equipment would be in a Nokia market.
Link to comment
Share on other sites

It's definitely a T-Mobile site for sure. I found it odd that Ericsson's equipment would be in a Nokia market.

There's a very good chance you are mistaking the new Nokia RAS for an Ericsson AIR.

 

It is very beefy, due to incorporating 2x RRH's inside the antenna enclosure.

 

Typical configuration for non-AWS-3 market would be FHFB + FRBG internal, FRIG external.

 

https://www.reddit.com/r/tmobile/comments/4sff69/brand_spanking_new_nokia_flexi_ras_radio_antenna/

  • Like 1
Link to comment
Share on other sites

There's a very good chance you are mistaking the new Nokia RAS for an Ericsson AIR.

 

It is very beefy, due to incorporating 2x RRH's inside the antenna enclosure.

 

Typical configuration for non-AWS-3 market would be FHFB + FRBG internal, FRIG external.

 

https://www.reddit.com/r/tmobile/comments/4sff69/brand_spanking_new_nokia_flexi_ras_radio_antenna/

True I didn't know that manufacturers other than Ericsson made those type of panels. Which band do you think their for in my market Band 12 or 66?
Link to comment
Share on other sites

True I didn't know that manufacturers other than Ericsson made those type of panels. Which band do you think their for in my market Band 12 or 66?

Bands 2/4/12. There is no AWS-3 spectrum owned by T-Mobile in that market. However, yes the antenna is capable of that frequency range.

 

If Jacksonville follows other markets getting this antenna, you will have L2100+L1900+L700+U1900 operating from this one antenna.

You will have a second antenna for G1900, and likely U2100, since Jacksonville is a 50 MHz AWS-1 market.

 

Keep 1c U2100, and for now 1c U19 for 2c UMTS, get to 10 MHz wide on L1900 from day 1. This gets to 70 MHz deployed LTE. (10 MHz of GSM, 20 MHz of UMTS)

 

Later as traffic migrated from UMTS to LTE, sunset U19 in favor of 15 MHz wide L19. Gets to 80 MHz of LTE (of 100 MHz of usable spectrum), with 1c U21 plus GSM.

 

With a tight enough grid, 80 MHz of LTE should handle T-Mobile's subscriber load for a while. Obviously high traffic sites will be slow no matter what, but sector splits, further densification can tighten up weak points needed as customer growth continues.

 

 

Sent from my iPhone using Tapatalk

  • Like 2
Link to comment
Share on other sites

True I didn't know that manufacturers other than Ericsson made those type of panels. Which band do you think their for in my market Band 12 or 66?

Tmobile basically does not have band 66 in Florida.

 

Sent from my SM-N920P using Tapatalk

Link to comment
Share on other sites

48 million dollars that's a lot of money

 

Sent from my XT1575 using Tapatalk

Link to comment
Share on other sites

48 million dollars that's a lot of money

 

Sent from my XT1575 using Tapatalk

It's more of a joke. They only pay like 7.5 million and the rest is to help poor students and discounts on accessories.  I guess Tmo is joining the helping the poor students train, but obviously not by choice.  I love how legere is "taking" credit for helping out students on twitter.

Edited by Hmight
Link to comment
Share on other sites

It's more of a joke. They only pay like 7.5 million and the rest is to help poor students and discounts on accessories. I guess Tmo is joining the helping the poor students train, but obviously not by choice. I love how legere is "taking" credit for helping out students on twitter.

At least it's Honesty

 

Sent from my XT1575 using Tapatalk

Link to comment
Share on other sites

T-Mobile only has band 66 in North Jersey

And judging from that map it's pretty much in Northwest Jersey. Coverage can be pretty bad on most carriers when you get all the way up there. Sussex Cellular used to be there but I can't remember what happened to them. They were an odd company.

Link to comment
Share on other sites

My parents are in town for the weekend and my mom has her US Cellular iPhone with. I was helping her with some typical older parent owning a smart phone type questions and noticed she had pretty strong signal for Sprint at my house. I pulled up field test and it's connected to B4. The device seems to be using T-Mobile LTE but Sprint for voice. Previously it's only used Sprint when visiting. Is USCC roaming onto T-Mobile new? That's crazy how it can switch providers pretty seamlessly.

  • Like 1
Link to comment
Share on other sites

My parents are in town for the weekend and my mom has her US Cellular iPhone with. I was helping her with some typical older parent owning a smart phone type questions and noticed she had pretty strong signal for Sprint at my house. I pulled up field test and it's connected to B4. The device seems to be using T-Mobile LTE but Sprint for voice. Previously it's only used Sprint when visiting. Is USCC roaming onto T-Mobile new? That's crazy how it can switch providers pretty seamlessly.

Are you sure it's not using T-Mobile for voice as well? Too bad you don't have an Android to confirm this.
Link to comment
Share on other sites

Are you sure it's not using T-Mobile for voice as well? Too bad you don't have an Android to confirm this.

 

US Cellular doesn't support VoLTE to my knowledge and is a CDMA carrier, so it would be quite unusual.  

 

- Trip

Link to comment
Share on other sites

US Cellular doesn't support VoLTE to my knowledge and is a CDMA carrier, so it would be quite unusual.

 

- Trip

US Cellular has been trailing VoLTE for a while now I thought.

 

In Jam 15, they expressed intent to trial in "select cities" within the year.

 

In Jan 16, they expressed plans to launch in one market, following trials in 3 markets. They also talked up the VoLTE roaming benefits.

 

In May 16, they spoke up about the 'VoLTE gap' for CDMA carriers, and didn't include any other time tables other than there was 'no rush' to ship the product.

 

Didn't want to link Fierce three times as sources, but quick googling should yield results corroborating that summary.

 

 

Sent from my iPhone using Tapatalk

  • Like 1
Link to comment
Share on other sites

I really wonder how T-mobile has band 4 @ 20 mhz across el paso and still it has congested in most areas. Is the network not dense enough maybe?? Or is T-mobile growth in this market really just that much

 

Sent from my SM-G928P using Tapatalk

 

Site density is huge for any carrier.

 

Otherwise you can go overcapacity relatively quickly depending on the area.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Similar Content

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...