Jump to content

Samsung Galaxy S4T L720T [Trimode] User Discussion Thread


lilotimz

Recommended Posts

Gotcha. I was confused myself. For those of you with the tri-band, who had the single band S4, hows your experience so far? I've read the phone is useless if you're not in a market that has all 3 bands.

 

 

In the Omaha market we only have B25 fired up so far.  The Tri-Band phone acts effectively like its single band counterpart - which is far from useless.  As the other bands come online or I visit other Spark markets, I'll have access to those bands as well.  Why would you think such a thing?  Isn't it common sense?

Link to comment
Share on other sites

As I understand it, once you fall off lte 4g, ecsfb is no longer relevant as you've already "fallen back" onto the same frequencies as voice.

 

ecsfb on some newly activated or reset towers can cause confusion and 'crashes' as discussed above in this thread. The problem, whatever it is, only seems to delay or block returns to lte. 3g didn't seem to be affected.

 

I recall no reports of what you're describing. Drops from lte to 3g always seem to be fast and near transparent.

 

You may be describing a new problem with unknown causes.

 

 

 

Sent from my SPH-L720T using Tapatalk

Seems as if I can get connection on 3g much much faster if I "update profile". Which to me doesn't seem right. Ha how's a guy supposed to stream music like that?

 

As far as ecsfb is concerned it seems to come back to 4g OK. Sometimes I have to cycle airplane mode if I'm in a known area and it hasn't switched. But that's not the norm.

 

Sent from my SPH-L720T using Tapatalk

 

 

Link to comment
Share on other sites

  • 2 weeks later...

Mine does.

 

 

 

No idea why though.

 

 

Sent from my SPH-L720T using Tapatalk

At least I'm not the only one lol. I still wish there was a LTE priority screen like other triband phones.

 

Sent from my SPH-L720T using Tapatalk

 

 

Link to comment
Share on other sites

How did you find out the band priority and is there anyway to change it?

 

Sent from my SPH-L720T using Tapatalk

You can set a Band scan preference. But after you connect, LTE is network controlled. The network will decide which band you need to be on. You have no control.

 

Robert via Nexus 5 using Tapatalk

 

 

  • Like 1
Link to comment
Share on other sites

I want to buy an s4t off of Craig's list but no one actually posts which model they have. How can I ask the seller what model they have? Specifically, where can I tell them to look to confirm its an s4t. Thanks in advance!

 

Also anyone willing to sell theirs??? :)

 

Sent from my Nexus 7 using Tapatalk

 

Link to comment
Share on other sites

I want to buy an s4t off of Craig's list but no one actually posts which model they have. How can I ask the seller what model they have? Specifically, where can I tell them to look to confirm its an s4t. Thanks in advance!

 

Sent from my Nexus 7 using Tapatalk

 

If its has the sun looking lte icon its the spark. The single band just has the original lte icon. Also the start up screen says sprint spark when turning on.

Link to comment
Share on other sites

If its has the sun looking lte icon its the spark. The single band just has the original lte icon. Also the start up screen says sprint spark when turning on.

 

is this the only way or is the l720t written under the battery somewhere?

Link to comment
Share on other sites

is this the only way or is the l720t written under the battery somewhere?

 

 

Without removing the battery - but still under the cover, it is molded into the center plastic of the lower antenna (right of the speaker, below the battery).  It says:  "L720T"

below that it says ">PC+ABS< #1-2"

 

If you remove the battery it reads:

Model: SPH-L720T

FCC ID: A3LSPHL720T

  • Like 1
Link to comment
Share on other sites

I live in a 1x800 area and I've noticed now that when I make or receive a phone call, it seems to be random whether it uses 800 or 1900. I know with my S3, it would scan 1900 first, then switch to 800 if the signal was weak. I live a few blocks from a tower so I would expect it would just use 1900 but even here it uses either seemingly random.

 

Does anyone know why the S4t does this? It's obviously not a problem, I'm just curious.

 

Sent from my GT-N5110 using Tapatalk

 

 

Link to comment
Share on other sites

I live in a 1x800 area and I've noticed now that when I make or receive a phone call, it seems to be random whether it uses 800 or 1900. I know with my S3, it would scan 1900 first, then switch to 800 if the signal was weak. I live a few blocks from a tower so I would expect it would just use 1900 but even here it uses either seemingly random.

 

Does anyone know why the S4t does this? It's obviously not a problem, I'm just curious.

 

Sent from my GT-N5110 using Tapatalk

 

Unfortunately, all I can do is speculate. I know on the LTE side of the shop, the network decides which band you connect too. Your experience seems to mimic that albeit, I am not sure the CDMA network is that 'smart.' Do you have any LTE in your area? I am curious what happens, if you set your phone to CDMA-only.

Link to comment
Share on other sites

I am in Shentel territory and have very good LTE coverage here. I haven't tried changing it to cdma only mode but I may try that at some point to see what happens.

 

Sent from my SPH-L720T using Tapatalk

 

 

Link to comment
Share on other sites

I may have missed this but does anyone's phone get stuck on 1x800 and never want to leave? I notice that when my phone switches to 800 and has an active data session, it does not switch back to LTE (or even 1900/EvDO) until I go into airplane mode. I've let it sit for about five to ten minutes and it doesn't want to let go.

Link to comment
Share on other sites

As long as you're steadily streaming data, it doesn't look.  If there is a periodic pause in the data stream, it will check.

Pandora often has gaps and doesn't steady stream and that gives the phone a chance to look.  Other apps may not stop very often.

 

If your 3g connection is weak or slow, there may not be any gaps for it to pause long enough to look.

 

As 4G fills in, this will become less of an issue as you will have a more constant 4g high data rate.

Link to comment
Share on other sites

As long as you're steadily streaming data, it doesn't look.  If there is a periodic pause in the data stream, it will check.

Pandora often has gaps and doesn't steady stream and that gives the phone a chance to look.  Other apps may not stop very often.

 

If your 3g connection is weak or slow, there may not be any gaps for it to pause long enough to look.

 

As 4G fills in, this will become less of an issue as you will have a more constant 4g high data rate.

 

Thanks - I figured this was the case. Otherwise, my new phone really loves going it slow on 2G technology.

Link to comment
Share on other sites

S4T gets wifi calling!

 

 

http://newsroom.sprint.com/blogs/devices-apps-and-services/tri-band-capable-samsung-galaxy-s-4-gets-wi-fi-calling.htm

 

Samsung Galaxy S 4® with Sprint Spark™ (enhanced LTE) becomes a fourth Wi-Fi Calling enabled smartphone from Sprint through an over-the-air update that started rolling out today. The update notification will be pushed to all our customers automatically during the next few weeks.
 
Wi-Fi Calling is a FREE service that lets you use voice and messaging services over existing home, office and public Wi-Fi networks. With Wi-Fi Calling, you will experience improved voice, data and messaging services in locations that previously had limited or no mobile network coverage.
 
How will customers benefit?
Enhanced coverage for in-building coverage or areas with challenging network conditions
Easy setup: Once activated, everything is seamless and happens in the background
Unlimited voice calling and messaging on Wi-Fi: All domestic calling and messaging is FREE (standard CDMA international rates apply for international calls)
Once the download is complete, you will be prompted to install the update. Installation will take a few minutes during which the device will be disabled. Once installation is completed, the device will be ready for use and Wi-Fi Calling can be activated by going to your Apps folder and selecting the Wi-Fi Calling icon.
 
Sprint plans to expand Wi-Fi calling to additional devices in 2014.

 

  • Like 4
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Similar Content

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...