Jump to content

Why didn't Sprint jump for "5G"?


ajr0203

Recommended Posts

No, I am fairly certain that I left my car at the airport in LTP-A 4E.

 

:P

 

AJ

I see mr.smartass. Let me break it down again. LTE-A 5G "LET-Advanced 5th generation" Would have been interesting.

Link to comment
Share on other sites

I see mr.smartass. Let me break it down again. LTE-A 5G "LET-Advanced 5th generation" Would have been interesting.

 

No, let Tears for Fears "Break It Down Again."

 

 

AJ

Link to comment
Share on other sites

 

 

If you are 20 years old, I bet that facial expression is your reaction to a lot of references beyond your years.

 

AJ

Link to comment
Share on other sites

Your endless teasing me is driving me crazy. When can you start publishing details?

There will be public information available by the start of 2014.  If i can say anything sooner, it will be on this forum. 

Oh, i know. But we're getting ahead of ourselves lol

Are we now?  :rolleyes:

Link to comment
Share on other sites

I suppose I need to do some scans of Sprint, VZW, and Cingular coverage brochures, circa 2000-2003, that I have archived somewhere.  Sprint native footprint is nearly the same now as it was then.  But VZW and Cingular (AT&T) have used their monopoly money to buy up everything else in site -- pun intended.  Many of you youngsters lack the age and experience to be aware of that.

 

AJ

" But VZW and Cingular (AT&T) have used their monopoly money to buy up everything else in site -- pun intended.  Many of you youngsters lack the age and experience to be aware of that.

"

I came on here to be taught and learn things I've never even heard of or cared about. But I really don't appreciate the age comment as it isn't needed. We all learn some time in life about stuff. I'm 20 and last time I checked, other 20 year olds are out being reckless and getting locked up and so much other stupid shit. I'm actually trying to learn something not very many 20 year olds would care about.

Link to comment
Share on other sites

LTE 5G WILL be interesting.

 

I promise  ;)

 

Given that true 4G is supposed to have 100Mbps-1Gbps peak speeds depending on whether you're stationary or moving, I can't imagine what actual 5G (and not some 4G+ transitional technology the marketing guys will try to slap the "5G" label on) will be able to accomplish while also maintaining some semblance of reliability, especially given that it's not likely that enough spectrum will be cleared for wide (100 MHz+) high power terrestrial carrier channels.

 

We all love our wireless broadband but sooner or later we as a country are going to have to bite the bullet and build out FTTH in an appreciable manner.

Link to comment
Share on other sites

I will not tolerate the excessive usage of memes. Keep it to a minimum or else infractions will be given. 

Is this so now? What two "meme's" Okay lolz I guess I'll respond with videos and caption instead. Btw Thanks for deleting ;)

There will be public information available by the start of 2014.  If i can say anything sooner, it will be on this forum. 

Are we now?  :rolleyes:

Yes we are lol. It's making me wonder what's going on behind the scenes :o

Link to comment
Share on other sites

Given that true 4G is supposed to have 100Mbps-1Gbps peak speeds depending on whether you're stationary or moving, I can't imagine what actual 5G (and not some 4G+ transitional technology the marketing guys will try to slap the "5G" label on) will be able to accomplish while also maintaining some semblance of reliability, especially given that it's not likely that enough spectrum will be cleared for wide (100 MHz+) high power terrestrial carrier channels.

 

We all love our wireless broadband but sooner or later we as a country are going to have to bite the bullet and build out FTTH in an appreciable manner.

Sir without spilling all the beans; I have a personal goal to give fiber access to every residential home/apt in the country.

  • Like 9
Link to comment
Share on other sites

All I know is that I am very curious and interested in what comes up with mobilesolutions in the next year. If I can dump Comcast, I will name my first born after him. I hope and pray it isn't Egor or Herman..

Link to comment
Share on other sites

All I know is that I am very curious and interested in what comes up with mobilesolutions in the next year. If I can dump Comcast, I will name my first born after him. I hope and pray it isn't Egor or Herman..

 

My name is William..not as bad as Herman. 

 

Though this is for the mobile side of the network, I have been out testing a set-up since around 5 and just finished up before dusk.  I am running 10Mhz TDD channels today, shot taken was at about 1/3 mile from the site (10 story building) I believe GPS thinks the height is 113 feet.  My device on the receiving end is a home-made Mikrotik setup with a 2200 mah battery.  This is not "5G" speeds, but it is quite good for mobile; and will make for an affordable consumer hotspot service. 

8zpatf.jpg

 

If i can dig it up, ill post the fully maxed out 10MHz sector.

  • Like 1
Link to comment
Share on other sites

What type of frequency for the downlink and what type of backhaul are you using?

 

I'll keep my mouth shut on the frequency, it is sub GHz though.  Back-haul is fiber; but will be a mix of Fiber & FOA. The site tested is the "master" and is fed via a direct line. 

 

AJ knows what frequencies i'm using and hasn't torched me..yet.

Link to comment
Share on other sites

I'll keep my mouth shut on the frequency, it is sub GHz though.  Back-haul is fiber; but will be a mix of Fiber & FOA. The site tested is the "master" and is fed via a direct line. 

 

AJ knows what frequencies i'm using and hasn't torched me..yet.

hmm... sub-Ghz, running a TDD setup?!?!  You using some of the unusable 700Mhz or squatting on some unused TV channel in 600Mhz?

Link to comment
Share on other sites

My name is William..not as bad as Herman.

 

Though this is for the mobile side of the network, I have been out testing a set-up since around 5 and just finished up before dusk. I am running 10Mhz TDD channels today, shot taken was at about 1/3 mile from the site (10 story building) I believe GPS thinks the height is 113 feet. My device on the receiving end is a home-made Mikrotik setup with a 2200 mah battery. This is not "5G" speeds, but it is quite good for mobile; and will make for an affordable consumer hotspot service.

Posted Image

 

If i can dig it up, ill post the fully maxed out 10MHz sector.

Holy Cow! Look at that ping time! I'm curious to know how performance stands at 3 miles from the site

 

 

Sent from Josh's iPhone 5 using Tapatalk 2

Link to comment
Share on other sites

Holy Cow! Look at that ping time! I'm curious to know how performance stands at 3 miles from the site

 

 

Sent from Josh's iPhone 5 using Tapatalk 2

 

Josh, I'll have to hurry, and i don't think the antenna's are aligned for 3 mile use.  I can double check some docs but i'm pretty sure the overlap zone on the next site is just 1 1/2 miles south.  Either way I'll drive till I fall off the network, then I'll turn back. 

 

Also if i have time to make it I'll try to grab a pic of the crew we have out today for the 2nd site,  And here soon I'll be able to do more real life testing ( in & out of buildings )

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Similar Content

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...