Jump to content

Phone connect 2


IamMrFamous07

Recommended Posts

Does anyone know if the new sprint phone connect 2 (landline) is compatible with the 800mhz band?

 

Yes, it is.   From this link:

 

http://newsroom.sprint.com/news/sprint-phone-connect-2-fact-sheet.htm

 

 

 

 

SPECIFICATIONS:
·         6.5 x 4.9 x 1.2 inches (164mm x 124mm x 31mm)
·         Dual band (800/1900 MHz CDMA)
  • Two RJ-11 ports (bridged) to support multiple devices

I started a topic on this device a week or so ago and got some good replies from folks who had used this device.  Check it out here if you want:

 

http://s4gru.com/index.php?/topic/3904-sprint-phone-connect-2/

Link to comment
Share on other sites

Since this is a Sprint device and Sprint lists on their website that it supports 800 CDMA, wouldn't that suggest it's Sprint's CDMA band and not Verizon's?  I'm not even sure they allow roaming on a "fixed" device like this.

Link to comment
Share on other sites

Since this is a Sprint device and Sprint lists on their website that it supports 800 CDMA, wouldn't that suggest it's Sprint's CDMA band and not Verizon's?  I'm not even sure they allow roaming on a "fixed" device like this.

 

I don't trust anyone when they say 800.   Huawei lists the Sprint and Verizon one as having 800.  Why would the Verizon one have 800SMR?  I bet you it's 850CDMA.  I could easily see the device having roaming capabilities for fall back purposes, after all it is peoples land lines with 911 service.  I bet you they have a close eye on roaming minutes though with these devices or maybe it goes to 911 only while roaming....  I bet it's the emergency call only deal kind of like how a TMobile phone does when it is in an area that they don't want you roaming on.

  • Like 1
Link to comment
Share on other sites

Yes, it does. Here's a pic from the back of the box of one.

 

G3VTniG.jpg

 

The notable section is: "Operates within Sprint's licensed frequency band of 800/1900 MHz (CDMA)." Sprint doesn't have any licensed 850/Cellular, so...

  • Like 2
Link to comment
Share on other sites

I can't find the FCC ID for that thing anywhere so can't look up the OET info.  I called the local Corporate Sprint store and that was an adventure in time wasting.  First, the guy told me it takes about an hour to port the number (which I know it takes longer than that) and when I asked about 800MHz his answer was that after Sprint shuts down Nextel they weren't doing anything with those frequencies.  I politely said Thank You and got off the phone with him as fast as I could.   :blink:

 

Called a non-Corporate store and the guy was much more knowledgeable.  Said it takes 2-3 days to port (which is more reasonable) but he wasn't sure on 800MHz support.  So he's going to e-mail an Account Executive and get an answer.  We'll see what kind of response I get.

Link to comment
Share on other sites

Yes, it does. Here's a pic from the back of the box of one.

...............

 

The notable section is: "Operates within Sprint's licensed frequency band of 800/1900 MHz (CDMA)." Sprint doesn't have any licensed 850/Cellular, so...

 

 

That clears it up.  And with that FCCID on the box, QISF253, I found the FCC OET filings.  It supports CDMA800 (Band Class 10) and CDMA1900.

 

Good news.  Thanks!

  • Like 1
Link to comment
Share on other sites

Yes, it does. Here's a pic from the back of the box of one.

 

 

 

The notable section is: "Operates within Sprint's licensed frequency band of 800/1900 MHz (CDMA)." Sprint doesn't have any licensed 850/Cellular, so...

 

Thanks for posting the pic!  I found the model number and the first part of the FCC ID and started digging but gave up after 10 minutes of looking through phone after phone.  I knew it was a F253 but never though it would just be simple..duh!

  • Like 1
Link to comment
Share on other sites

Here's the report if anyone wants to look at it....  https://apps.fcc.gov/eas/GetApplicationAttachment.html?id=1736507

 

Looks like it supports BC0, 1, and 10.  So PCS, Cellular 850, and 800SMR.  Very cool!  Curious of the PRL of how the priorities and such are setup though. 

 

EDIT:  Funny how the pics show a NiMH battery but the test report shows Li-Ion.

  • Like 2
Link to comment
Share on other sites

Here's the report if anyone wants to look at it....  https://apps.fcc.gov/eas/GetApplicationAttachment.html?id=1736507

 

Looks like it supports BC0, 1, and 10.  So PCS, Cellular 850, and 800SMR.  Very cool!  Curious of the PRL of how the priorities and such are setup though. 

 

EDIT:  Funny how the pics show a NiMH battery but the test report shows Li-Ion.

Our store has a demo Phone Connect 2 I could... "borrow" and see. It's got a USB port, so theoretically something like QPST should work (though I have no idea how to do that).

 

Edit: battery is definitely NiMh inside it.

Link to comment
Share on other sites

I bet you'd need some sort of drivers and then no idea if the USB port is for a host or device or both.  The manual says it would void the warranty.  I wouldn't mess with it in case it decides to leak the magical smoke that makes electronics run.

Link to comment
Share on other sites

I can't find the FCC ID for that thing anywhere so can't look up the OET info.  I called the local Corporate Sprint store and that was an adventure in time wasting.  First, the guy told me it takes about an hour to port the number (which I know it takes longer than that) and when I asked about 800MHz his answer was that after Sprint shuts down Nextel they weren't doing anything with those frequencies.  I politely said Thank You and got off the phone with him as fast as I could.   :blink:

 

Called a non-Corporate store and the guy was much more knowledgeable.  Said it takes 2-3 days to port (which is more reasonable) but he wasn't sure on 800MHz support.  So he's going to e-mail an Account Executive and get an answer.  We'll see what kind of response I get.

 

Again let me give you a heads up, that it took 10 days for me to get my landline number from Verizon ported over to Sprint. But I have to say that the quality on sound is much better than my land line.  I've only had it for 2 days and very happy with it so far.

  • Like 1
Link to comment
Share on other sites

I bet you'd need some sort of drivers and then no idea if the USB port is for a host or device or both.  The manual says it would void the warranty.  I wouldn't mess with it in case it decides to leak the magical smoke that makes electronics run.

 

Experimentation!

 

Ah the magical purple smoke. The beauties of being a tech in a corporate location... you make the ticket notes for exchange reason. Warranty doesn't matter for store demo devices, the store will always have a working one on hand. Doesn't matter if hte device is broken fro muse, intentionally by a customer, or stolen, it will be replaced. And that sounds like a DOA device if I ever saw one... hehe

 

"Multiple batteries and leaving on charger for 2+ hours did not bring device back to life. Exchanging in store with stock on hand."  :P

Link to comment
Share on other sites

I called the local Corporate Sprint store and that was an adventure in time wasting.  First, the guy told me it takes about an hour to port the number (which I know it takes longer than that).

 

Called a non-Corporate store and the guy was much more knowledgeable.  Said it takes 2-3 days to port (which is more reasonable) but he wasn't sure on 800MHz support.

 

Number portability is an inexact science unfortunately and relies more on the company it is coming from than the company it is going to. Landline ports regularly take anywhere from 1-10 days. Wireless ports are usually anywhere from 15 minutes to 4 days (those were the fun ones).

 

As for 800mhz support questions, Sprint's official corporate stance currently is not to talk about the frequencies specific devices support. I'm assuming this is because they are deciding how to advertise this in the future. After all, advertising a domestic quad-band-phone (800/850/1900/2500) means it must be inferior to a sextuple-band phone (800/850/900/1800/1900/2500, incorporating int'l GSM here obviously). hehe

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • large.unreadcontent.png.6ef00db54e758d06

  • gallery_1_23_9202.png

  • Posts

    • Since this is kind of the general chat thread, I have to share this humorous story (at least it is to me): Since around February/March of this year, my S22U has been an absolute pain to charge. USB-C cables would immediately fall out and it progressively got worse and worse until it often took me a number of minutes to get the angle of the cable juuuussst right to get charging to occur at all (not exaggerating). The connection was so weak that even walking heavily could cause the cable to disconnect. I tried cleaning out the port with a stable, a paperclip, etc. Some dust/lint/dirt came out but the connection didn't improve one bit. Needless to say, this was a MONSTER headache and had me hating this phone. I just didn't have the finances right now for a replacement.  Which brings us to the night before last. I am angry as hell because I had spent five minutes trying to get this phone to charge and failed. I am looking in the port and I notice it doesn't look right. The walls look rough and, using a staple, the back and walls feel REALLY rough and very hard. I get some lint/dust out with the staple and it improves charging in the sense I can get it to charge but it doesn't remove any of the hard stuff. It's late and it's charging, so that's enough for now. I decide it's time to see if that hard stuff is part of the connector or not. More aggressive methods are needed! I work in a biochem lab and we have a lot of different sizes of disposable needles available. So, yesterday morning, while in the lab I grab a few different sizes of needles between 26AWG and 31 AWG. When I got home, I got to work and start probing the connector with the 26 AWG and 31 AWG needle. The stuff feels extremely hard, almost like it was part of the connector, but a bit does break off. Under examination of the bit, it's almost sandy with dust/lint embedded in it. It's not part of the connector but instead some sort of rock-hard crap! That's when I remember that I had done some rock hounding at the end of last year and in January. This involved lots of digging in very sandy/dusty soils; soils which bare more than a passing resemblance to the crap in the connector. We have our answer, this debris is basically compacted/cemented rock dust. Over time, moisture in the area combined with the compression from inserting the USB-C connector had turned it into cement. I start going nuts chiseling away at it with the 26 AWG needle. After about 5-10 minutes of constant chiseling and scraping with the 26AWG and 31AWG needles, I see the first signs of metal at the back of the connector. So it is metal around the outsides! Another 5 minutes of work and I have scraped away pretty much all of the crap in the connector. A few finishing passes with the 31AWG needle, a blast of compressed air, and it is time to see if this helped any. I plug my regular USB-C cable and holy crap it clicks into place; it hasn't done that since February! I pick up the phone and the cable has actually latched! The connector works pretty much like it did over a year ago, it's almost like having a brand new phone!
    • That's odd, they are usually almost lock step with TMO. I forgot to mention this also includes the September Security Update.
    • 417.55 MB September security update just downloaded here for S24+ unlocked   Edit:  after Sept security update install, checked and found a 13MB GP System update as well.  Still showing August 1st there however. 
    • T-Mobile is selling the rest of the 3.45GHz spectrum to Columbia Capital.  
    • Still nothing for my AT&T and Visible phones.
  • Recently Browsing

    • No registered users viewing this page.
×
×
  • Create New...